Bixolon SRP-275 SRP-275AG/IFL User Manual

 

R/W error in memory 
or gate array 

After R/W checking, the 
printer does not work 
correctly. 
Writing to, reading out, or 
erasing the NV memory for 
image scanning results 
does not work correctly. 

Recovers automatically 
when the rear cover is 
closed. 

High voltage error 

The power supply voltage 
is extremely high. 

Impossible to recover. 

Low voltage error 

The power supply voltage 
is extremely low. 

Impossible to recover. 

CPU execution error 

The CPU executes an 
incorrect address or I/F 
board is not connected. 

Impossible to recover. 

Print head temperature 
detection circuit error. 

There is an abnormality is 
the print head temperature.

 200ms 

     

 

Impossible to recover. 

 

If you see this light blinking, turn off the printer for a few seconds and then turn it back on. 
If the light is still blinking, call your supervisor or a service person. 

 

 

•

- Make sure that the printer is turned on. 

- Make sure that the power supply cable is correctly plugged into the printer and to the power outlet. 

 

•

- If the POWER LED is blinking, the printer is not ready yet. 

Wait until the light quits blinking and the printer is ready to use. 

- If the ERROR LED is on (but not blinking), the printer is off line. Check to see that the covers are closed 

and check the paper state. See Chapter 5 for instructions on installing or replacing the paper roll. 

- If the ERROR LED is blinking, there is an error. In this case, turn off the printer for a few seconds and 

then turn it back on. If the light is still blinking, call your supervisor or service person. 

- If the PAPER OUT LED is on, check the paper roll in the printer. See Chapter 5 for instruction on 

installing the paper roll.