Juniper 1 port ADSL2+ Annex B Mini Physical Interface Module JXM-1ADSL2-B-S Data Sheet
Product codes
JXM-1ADSL2-B-S
Datasheet
Page
Juniper Networks ADSL2/2+ Mini-PIM
The Juniper Networks ADSL2/2+ Mini-Physical Interface
Modules (Mini-PIMs) are for use with the SSG 20 platform.
The ADSL2/2+ Mini-PIMs, one supporting Annex A (over
POTS) and the other Annex B (over ISDN), each include
one physical ADSL port that support ADSL, ADSL2 or
ADSL2+ protocols.
Modules (Mini-PIMs) are for use with the SSG 20 platform.
The ADSL2/2+ Mini-PIMs, one supporting Annex A (over
POTS) and the other Annex B (over ISDN), each include
one physical ADSL port that support ADSL, ADSL2 or
ADSL2+ protocols.
Specifications
Product Number
Description
JXM-1ADSL2-A-S
1 Port ADSL 2/2+ interface card with Annex A
(over POTS) support, RJ-11
JXM-1ADSL2-B-S
1 Port ADSL 2/2+ interface card with Annex B
(over ISDN) support, RJ-45
ScreenOS Software Release
ADSL2/2+ Annex A and Annex B functionality is supported in ScreenOS 5.4 or greater
Dimensions (W x L x H) and Weight
- 3.75” x 5.9” x 0.80”
- 9.5 cm x 14.5 cm x 2.0 cm
- 0.17 lb. (77.1g)
- 9.5 cm x 14.5 cm x 2.0 cm
- 0.17 lb. (77.1g)
ATM
- ATM Adaptation Layer 5 (AAL5)
- Up to 10 Permanent Virtual Circuits (PVCs) per card
- CBR, VBR-nrt and UBR
- Up to 10 Permanent Virtual Circuits (PVCs) per card
- CBR, VBR-nrt and UBR
Environmental
Operating temperature: 0-40°C
Storage temperature: -40 to 70°C
Relative humidity: 5% to 90% non-condensing
Storage temperature: -40 to 70°C
Relative humidity: 5% to 90% non-condensing
Diagnostics
- OAM F4 far loopback test
- OAM F4 near loopback test
- OAM F5 far loopback test
- OAM F5 near loopback test
- OAM F4 near loopback test
- OAM F5 far loopback test
- OAM F5 near loopback test
LEDs
PIM LED’s indicate port status with the following LED states:
- SYNC - Green
- TX/RX - Green
- SYNC - Green
- TX/RX - Green
Management Capabilities Telnet/Console/Web
Remote and local configuration, monitoring, and troubleshooting
The Juniper Networks single-port ADSL2/2+ Mini Physical Interface
Modules (Mini-PIM) for the SSG 20 platform complement the five on-
board 10/100 Ethernet interfaces with expanded WAN connectivity.
The ADSL2/2+ Annex A (over POTS) and ADSL2/2+ Annex B (over
ISDN) both include one physical port with support for ADSL, ADSL2 or
ADSL2+ protocols.
Modules (Mini-PIM) for the SSG 20 platform complement the five on-
board 10/100 Ethernet interfaces with expanded WAN connectivity.
The ADSL2/2+ Annex A (over POTS) and ADSL2/2+ Annex B (over
ISDN) both include one physical port with support for ADSL, ADSL2 or
ADSL2+ protocols.
Features
• Automatic configuration of ADSL line after negotiating with the
DSLAM minimizing configuration
• One RJ-11 or RJ-45 ADSL Interface
• Supports ADSL, ADSL2 and ADSL2+ protocols on the same
• Supports ADSL, ADSL2 and ADSL2+ protocols on the same
interface card
• Dying Gasp support
• MLPPP over two ADSL Cards
• Supports ATM AAL5 with CBR, VBR-nrt and UBR traffic types
• MLPPP over two ADSL Cards
• Supports ATM AAL5 with CBR, VBR-nrt and UBR traffic types