Intel E7-4870 v2 CM8063601272606 User Manual
Product codes
CM8063601272606
Integrated I/O (IIO) Configuration Registers
330
Intel
®
Xeon
®
Processor E7-2800/4800/8800 v2 Product Family
Datasheet Volume Two: Functional Description, February 2014
12:12
RW1CS
0x0
cmp_addr_err:
Completion Address Error. The DMA channel sets this bit
indicating that the completion address register was configured
to an illegal address or has not been configured.
11:11
RW1CS
0x0
desc_len_err:
Descriptor Length Error. The DMA channel sets this bit
indicating that the current transfer has an illegal length field
value. When this bit has been set, the address of the failed
descriptor is in the Channel Status register.
10:10
RW1CS
0x0
desc_ctrl_err:
Descriptor Control Error. The DMA channel sets this bit
indicating that the current transfer has an illegal control field
value. When this bit has been set, the address of the failed
descriptor is in the Channel Status register.
9:9
RW1CS
0x0
wr_data_err:
Write Data Error. The DMA channel sets this bit indicating that
the current transfer has encountered an error while writing the
destination data. This error could be because of an internal ram
error in the write queue that stores the write data before being
written to main memory. When this bit has been set, the
address of the failed descriptor is in the Channel Status
register.
8:8
RW1CS
0x0
rd_data_err:
Read Data Error. The DMA channel sets this bit indicating that
the current transfer has encountered an error while accessing
the source data. This error could be a read data that is received
poisoned. When this bit has been set, the address of the failed
descriptor is in the Channel Status register.
7:7
RW1CS
0x0
dma_data_parerr:
DMA Data Parity Error. The DMA channel sets this bit indicating
that the current transfer has encountered an uncorrectable
ECC/parity error reported by the DMA engine.
6:6
RW1CS
0x0
cdata_parerr:
Data Parity Error. The DMA channel sets this bit indicating that
the current transfer has encountered a parity error. When this
bit has been set, the address of the failed descriptor is in the
Channel Status register.
5:5
RW1CS
0x0
chancmd_err:
CHANCMD Error. The DMA channel sets this bit indicating that a
write to the CHANCMD register contained an invalid value (e.g.
more than one command bit set).
4:4
RW1CS
0x0
chn_addr_valerr:
Chain Address Value Error. The DMA channel sets this bit
indicating that the CHAINADDR register has an illegal address
including an alignment error (not on a 64-byte boundary).
Type:
CFG
PortID:
N/A
Bus:
0
Device:
4Function:0-7
Offset:
0x180
Bit
Attr
Default
Description