Psiber Data Psiber Cable tester, cable tester 226502 User Manual

 Plug the wire into the correct Test Port, e.g. Ethernet to RJ45

 Plug the opposite end  into the Main Remote

 Press Network  Button

The LCD Display reports wire condition, Pass/Fail

 To turn off,  press O/ID Button

    With the unit turned OFF, hold down  the LENGTH/TONE button until 

LCD illuminates

To select a tone  cadence, press the LENGTH/TONE button  repeatedly to 

step through the four cadence options: HI, LO, Hi-Lo1, and  Hi-Lo 2. Stop  

when  you reach the option  you want.  The option  you select determines the 

cadence sent from the main tester, through the cable, and  picked up by the 

tone  tracer probe*.

Press the appropriate cable type button (voice, video or data)  to select a 

cable for the tone  signal

 Tone is detected by a tone  tracer probe (optional)

Make sure  the CM450 is turned OFF.

Insert the cable plug into the corresponding receiver on the main tester  

(RJ-11/RJ12)  jack for  voice cable, RJ-45 jack for data cables, F-Connector 

for video cables).

Press the LENGTH/TONE button to enter  Length  Mode.

Press the cable type  button corresponding to the connector  in use

CM450 shows Opens, Shorts, Miswires, Split Pairs,  PASS and

FAIL results quickly.

 CM450`s built- in tone generator is a flexible and function- packed 

Tone generator. Its configurable signal can be generated to find and fix the 

position on any type of cable – either exposed or hidden, in ceilings or 

behind walls.

 CM450 determines the length (in feet or meters) of an entire cable and/ 

or individual wire pairs within the cable.

CM450 is supported by (1-19) wiremapping ID locators (Network/Coax) 

and (1-8) testing/ID remotes (Network/Telephone).