Ubiquiti UNIFI ACCESSPOINT 3ER PACK UAP-LR-3 User Manual

30

Chapter 10: Access Point Details

UniFi AP/AP-LR User Guide

 Ubiquiti Networks, Inc.

UniFi Access Points connect to the UniFi Controller 
software either by Ethernet, denoted as Connected or by 
a wireless connection, denoted as Connected (wireless). 
Based on connection type, options under each tab vary.
The upper part of the window has 4 clickable tabs. The 
bottom of the window has a Locate and Restart button. 
Use the Locate button to flash the LED on the Access 
Point and flash the Access Point icon on the map. Use 
the Restart button to restart the Access Point. The 4 tabs 
include: Details, Users, Guests, and Configuration.

Displays details about the Access Point. Click Overview 
to display the device specifics, connection details, uptime 
and user statistics.

Displays the MAC address of the Access 

Point. 

Displays the model information.

Displays the version of software used on the 

Access Point.

Displays the IP address of the Access Point.

Displays the amount of time the Access Point has 

been running without interruption. 

Displays the number of users connected to the 

primary network.

Displays the number of users connected to the 

guest network.

Displays details on a wirelessly-connected Access Point 
including the Uplink Access Point (by specified name or 
MAC address), signal strength to the Uplink Access Point, 
TX Rate, RX Rate, Down Pkts / Bytes, Up Pkts / Bytes and 
Activity. See “Wireless Uplinks” on page 35 to find, 
select and connect to a wireless Access Point.

Displays details on a wired Access Point including the 
connection speed, duplex type, Down Pkts / Bytes in K/M, 
Up Pkts / Bytes in K/M and Activity in B/sec.