TP-LINK AV500 TL-WPA4230P KIT User Manual

 

20

 

4. Click 

the Add New... button and enter the MAC address 00-0A-EB-00-07-BE in the MAC Address 

field, enter Wireless Station A in the Description field and select Enabled in the Status pull-down 
list. Click the Save button. 

The filtering rules that configured should be similar to the following list: 

   



If you enable the function and select Deny the stations not specified by any enabled entries in the 
list to access for Filtering Rules but there isn’t any enabled entry in the list, thus, no wireless stations 
can access the device. 

Selecting Wireless > Wireless Advanced will allow you to do some advanced settings for the device in 
the following screen shown in Figure 3-16. As the configuration for each operation mode is almost the 
same, we take Access Point mode for example here. 

 

Figure 3-16 Wireless Advanced 



 

Transmit Power - Specifies the transmit power of the device. You can select High, Middle or Low 
based on your need. High is the default setting and is recommended.   



 

Beacon Interval - Specifies a value between 40-1000 milliseconds. The beacons are the packets 
sent by the device to synchronize a wireless network. Beacon Interval value determines the time 
interval of the beacons. The default value is 100.   



 

RTS Threshold - Specifies the RTS (Request to Send) Threshold. If the packet is larger than the 
specified RTS Threshold size, the device will send RTS frames to a particular receiving station and 
negotiate the sending of a data frame. The default value is 2346.   



 

Fragmentation Threshold - This value is the maximum size determining whether packets will be 
fragmented. Setting the Fragmentation Threshold too low may result in poor network performance 
since excessive packets. 2346 is the default setting and is recommended.