Neutrik BNC connector Plug, straight 75 Ω NBLC 75 BSX 14 1 pc(s) NBLC75BSX14 Information Guide

126

A

B

A

B

B

A

A

B

A

B

A

B

A

B

A

B

The NYS-SPP-L1 is a economical and remarkable sleek 
designed 1/4“ modular Patch Panel for 19“ rack mount (19“ 
x 1U) with a reinforced metal housing. Each of it‘s 48 PCB 
wired balanced channels (24 front pairs and correspond-
ing 24 rear pairs) can either be grounded separately or in 
groups of inividually chooseable channel numbers (detailed 
information see below).

The PCBs are held securely in place by being clamped 
between the front and the rear panel, this grants an easy 
reconfiguration of the Patch Panel without the danger of 
loosing any small parts (e.g. nuts). The grey jack serves as an 
easy and distinguishable normalling identification.

Standard configuration, when delivered, is Half Normalled 
bottom row. The configuration can easily be changed by 
just flipping the individual PCB. Inserting a plug into the 

grey jack will always isolate the top against the bottom row. 
Alternative solution for send/return applications by use of 
NYS-SPCR1 module (see accessories below).

The following configurations are available:

The flexible grounding system, applicable for each channel separately by simply attaching the loose supplied grounding clips 
to the grounding pad of the corresponding channel, offers the following alternatives:

Individual (without grounding clip): Each channel ground (sleeve contact) is connected to the dedicated ground

    contact of the incoming 1/4” plug only. This is the standard configuration for delivery.

Chassis common c: The relevant channel grounds (sleeve contacts;  top and bottom row) is connected to the   

 

    ground flat tab via grounding clip and chassis.

Chassis top d: The dedicated top channel ground (sleeve contact) is connected to the ground flat tab via grounding

    clip and chassis.

Chassis bottom e: The dedicated bottom channel ground (sleeve contact) is connected to the ground flat tab via

    grounding clip and chassis.

grounding clip (slide onto the print)

Rear view detail:  
Ground flat tab to be used with 
FASTON

®

 receptacle or to solder 

the wire.

front

rear

front

rear

front

rear

front

rear

Front jack A for "listen in"

Grey B jack for signal

insertion

Allows 1 output to feed 2 inputs

Upper (A) and lower (B)

channel separated

Solution for insert jack of mixing consoles
Split print by-passes the use of a specially 
wired Y-cable.

A Front

Mono - Send

Rear

Send -

 Return

(Stereo Jack)

B Front

Mono - Return

(Red Jack)

NYS-SPCR1

Half Normalled 

 

Split

Isolated

Split Print