Velleman HPG1 Function Generator, Frequency Generator HPG1 Data Sheet

- 8 -

 

Select the desired waveform  

(sine, square or triangle)

 

Select the desired frequency 

(1Hz ... 1.000.000Hz)

 

Select the desired frequency step 

(1Hz, 10Hz, 100Hz, 1kHz or 10kHz) this setting is used 
for above frequency change

 

Select the desired output level 

(dBm/Vrms or Vpp depends on signal)

 

A sweep generator generates a frequency which changes with respect to time and is a practical 
device for recording frequency characteristics, or to make automated measurements. 

Speed at which the signal 
sweeps from minimum to 
maximum or  turn the sweep 
function OFF

 

Keep the menu button pressed to exit the sweep 
menu, if the sweep is active then you will see the 
screen on the left. You can select the desired 
waveform and output level 

Waveform screen if Sweep is On 

Minimum or start frequency at 
which the signal starts 

Maximum or stop frequency at which 
the signal stops 

Select the desired frequency step (1Hz, 
10Hz, 100Hz, 1kHz or 10kHz) this 
setting is used for above frequency 
change

 

Selection of the loop sweep function of 
the signal: 

- 

Lin. :  linear from minimum to maximum, then restart 
from min to max. 

- 

Log : logarithmic from minimum to maximum, then 
restart from min to max. 

- 

Bi-lin : linear from minimum to maximum and back to 
minimum ... 

- 

Bi-log : logarithmic from minimum to maximum and 
back to minimum ...