Rigol DS2072A 2-channel oscilloscope, Digital Storage oscilloscope, DS2072A User Manual
Product codes
DS2072A
RIGOL
DS2000A User’s Guide
15-2
Remote Control via USB
1. Connect the device
Connect the oscilloscope (USB DEVICE) with your PC using a USB cable.
2. Install the USB driver
This oscilloscope is a USBTMC device. Assuming that your PC has already been
installed with Ultra Sigma, after you connect the oscilloscope to the PC and
turn both on for the first time (the oscilloscope is automatically configured to
USB interface), the New Hardware Wizard as shown in the figure below is
displayed on the PC. Please install the “USB Test and Measurement Device”
driver following the directions in the wizard. The steps are as follows.
installed with Ultra Sigma, after you connect the oscilloscope to the PC and
turn both on for the first time (the oscilloscope is automatically configured to
USB interface), the New Hardware Wizard as shown in the figure below is
displayed on the PC. Please install the “USB Test and Measurement Device”
driver following the directions in the wizard. The steps are as follows.
1
2