Rigol DS2302A-S 2-channel oscilloscope, Digital Storage oscilloscope, DS2302A-S User Manual
Product codes
DS2302A-S
RIGOL
DS2000A User’s Guide
12-9
Haversine
The schematic diagram of Haversine function waveform is as shown in the figure
below.
below.
Lorentz
The schematic diagram of Lorentz function waveform is as shown in the figure below.
Press Src1 Setup to open the waveform setting menu. Press Wave and select
“Built-in”. At this point, you can set the output signal parameters according to the
type of the built-in waveform seelcted.
1. Source
“Built-in”. At this point, you can set the output signal parameters according to the
type of the built-in waveform seelcted.
1. Source
Press Source to turn on or off the signal output.
2. Select built-in waveform
Press Built-in to select any of the 7 built-in waveforms.
3. Set the frequency
Press Frequency to set the frequency of the signal. The range is from 100 mHz
to 1 MHz.
to 1 MHz.