Rigol DS2102A 2-channel oscilloscope, Digital Storage oscilloscope, DS2102A User Manual
Product codes
DS2102A
RIGOL
DS2000A User’s Guide
1-11
a) Turn off the instrument and remove the power cord.
b) Insert a small straight screw driver into the groove at the power socket and
b) Insert a small straight screw driver into the groove at the power socket and
prize out the fuse seat gently.
c) Take out the fuse and replace it with a specified one. Reinstall the fuse seat.
5. AC Power Socket
AC power input terminal. The power requirements of this oscilloscope are
100-240 V, 45-440 Hz. Use the power cord provided with the accessories to
connect the instrument to AC power. Then, you can press the power key at the
front panel to start the instrument.
100-240 V, 45-440 Hz. Use the power cord provided with the accessories to
connect the instrument to AC power. Then, you can press the power key at the
front panel to start the instrument.
6. Lock Hole
You can lock the instrument to a fixed location using the security lock (please
buy it yourself) via the lock hole.
buy it yourself) via the lock hole.
7. Trigger Out
The oscilloscope outputs a signal that can reflect the current capture rate of the
oscilloscope at each trigger via this interface. Connect this signal to a waveform
display device to measure the frequency of the signal and the measurement
result should be the same with the current capture rate.
oscilloscope at each trigger via this interface. Connect this signal to a waveform
display device to measure the frequency of the signal and the measurement
result should be the same with the current capture rate.
8. Signal Output
When the corresponding signal source 1 or signal source 2 is enabled, the
current signal can be output to the analog channel output terminal of the
oscilloscope or the external device connected via [Source 1] or [Source 2].
This function is only applicable to DS2000A-S.
current signal can be output to the analog channel output terminal of the
oscilloscope or the external device connected via [Source 1] or [Source 2].
This function is only applicable to DS2000A-S.