Ultralife ER14505M, AA Size 2000mAh Lithium Battery Cell 3.6V ER14505M Data Sheet
Product codes
ER14505M
- Page 3/5 -
MSDS Li-SOCl
2
Rev 2.Dec.2004
6. Accidental release measures
In case of break of a battery, all the people must go away from the place where the
incident happened and come back only after the dissolution of the irritating gas.
Broken batteries or battery packs must be covered with sodium carbonate (Na
incident happened and come back only after the dissolution of the irritating gas.
Broken batteries or battery packs must be covered with sodium carbonate (Na
2
CO
3)
or dry
sand, place them in approved container and dispose in accordance with local regulation.
For the eventual handling use gloves in Viton
For the eventual handling use gloves in Viton
®.
7. Handling and storage
7.1 Handling: - Do not recharge
- Do not use different types and brands of batteries or with different state
charge
- Avoid short circuit
- Use desk of work electrically insulated
- Avoid to work over wet surface
- Use plastic calibre to valuate the dimensions of a Lithium battery or to
charge
- Avoid short circuit
- Use desk of work electrically insulated
- Avoid to work over wet surface
- Use plastic calibre to valuate the dimensions of a Lithium battery or to
insulate the metallic surface of the battery
- Do not have rings on the fingers; otherwise wear insulating gloves.
- Do not cut in the same time both the terminals of a battery: it could be a
- Do not cut in the same time both the terminals of a battery: it could be a
short circuit trough the shears
- Keep the batteries in non-conductive trays (i.e. plastic, wood or carton)
- Do not solder directly on the battery
- Do not disassemble the batteries, do not throw them in the fire, do not
- Do not solder directly on the battery
- Do not disassemble the batteries, do not throw them in the fire, do not
hole, do not overheat or plunge into water
7.2 Storage:
- Store the Lithium cells in a cool, dry and ventilated area far from fires and
heating sources.
- It is recommended the use of a non-combustible structure, keep adequate
- It is recommended the use of a non-combustible structure, keep adequate
clearance between walls and batteries.
- The maximum temperature suggested for the storage is +30°C
- Higher temperatures are allow but cause an increase in the self discharge
- The maximum temperature suggested for the storage is +30°C
- Higher temperatures are allow but cause an increase in the self discharge
of the battery and speed up the process of passivation
- in any case, never go over 100 °C, as the batteries can break and cause
a leakage
- Arrange adequate protections to avoid possible hurts to the batteries
- Keep the batteries in their original packages till when they are used
- Do not expose the batteries directly to the sun light
- Do not put an higher number of cartons one on another (respect what
- Keep the batteries in their original packages till when they are used
- Do not expose the batteries directly to the sun light
- Do not put an higher number of cartons one on another (respect what
indicated)
- If in the same place are storage batteries with a total capacity
> 50,000 Ah, it is suggested to install an alarm for smoke and gas
> 50,000 Ah, it is suggested to install an alarm for smoke and gas