Fluke 1652C05-TPOLEKITVDE-tester 4426016 User Manual

16 

Various error conditions are detected by the tester and are indicated with the 


 icon, “Err”, and an error number on the primary display. See Table 7. These 

error conditions disable testing and, if necessary, stop a running test. 

Self-Test Fails 

1 

Return the tester to a Fluke Service Center. 

Over-Temp 

2 

Wait while the tester cools down. 

Fault Voltage 

4 

Check the installation, in particular, the voltage 
between N and PE. 

Excessive Noise 

5 

Switch off all appliances (Loop, RCD 
measurements) and move the earth stakes 
(earth measurement). 

Excessive Probe 
Resistance 

6 

Put the stakes deeper into the soil. Tamp 
down the soil directly around the stakes. Pour 
water around the stakes but not at the earth 
ground under test. 

 

apx032f.eps