Sony CDX-DAB500U User Manual
20
4
Press
(BACK) to return to the
previous display.
Tip
The DM+ setting can be memorized for each
source other than the tuner.
source other than the tuner.
Using rear speakers as
subwoofer — Rear Bass
Enhancer
subwoofer — Rear Bass
Enhancer
Rear Bass Enhancer enhances the bass
sound by applying a low pass filter setting
(page 22) to the rear speakers. This function
allows the rear speakers to work as a
subwoofer if one is not connected.
sound by applying a low pass filter setting
(page 22) to the rear speakers. This function
allows the rear speakers to work as a
subwoofer if one is not connected.
1
During reception/playback, press
, rotate the control dial until
“SOUND” appears, then press it.
, rotate the control dial until
“SOUND” appears, then press it.
2
Rotate the control dial until “RB ENH”
appears, then press it.
appears, then press it.
3
Rotate the control dial until “RBE
MODE” appears, then press it.
MODE” appears, then press it.
4
Rotate the control dial to select from
“1,” “2” or “3,” then press it.
“1,” “2” or “3,” then press it.
5
Press
(BACK) to return to the
previous display.
Using a subwoofer without a
power amplifier —
Subwoofer Direct Connection
power amplifier —
Subwoofer Direct Connection
You can use the subwoofer without a power
amplifier when it is connected to the rear
speaker cord.
amplifier when it is connected to the rear
speaker cord.
Note
Be sure to connect a 4 - 8 ohm subwoofer to
either of the rear speaker cords. Do not connect a
speaker to the other rear speaker cord.
either of the rear speaker cords. Do not connect a
speaker to the other rear speaker cord.
1
During reception/playback, press
, rotate the control dial until
“SOUND” appears, then press it.
, rotate the control dial until
“SOUND” appears, then press it.
2
Rotate the control dial until “SW
DIREC” appears, then press it.
DIREC” appears, then press it.
3
Rotate the control dial until “SW
MODE” appears, then press it.
MODE” appears, then press it.
4
Rotate the control dial to select “1,” “2”
or “3,” then press it.
or “3,” then press it.
5
Press
(BACK) to return to the
previous display.
For details on the settings for the subwoofer
phase, position, low pass filter frequency
and the low pass filter slope, see page 22.
phase, position, low pass filter frequency
and the low pass filter slope, see page 22.
Adjusting setup items
1
Press
, rotate the control dial
until the desired category appears, then
press it.
press it.
2
Rotate the control dial until the desired
item appears, then press it.
item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.
setting, then press it.
*
The setting is complete.
4
Press
(BACK) to return to the
previous display.
* For CLOCK-ADJ and BTM settings, step 4 is
not necessary.
The following items can be set depending
on the source and setting:
on the source and setting:
GENERAL:
CLOCK-ADJ
(Clock Adjust) (page 5)
CAUT ALM
*
1
(Caution Alarm)
Activates the caution alarm: “ON,”
“OFF” (page 5).
“OFF” (page 5).