AEG AR 4021 BT 400402 User Manual

84

Carefully slide the unit into the sleeve until it locks 

 

‹

into place.

Press 

 

‹

RESET (30) with a pen or other pointed object 

after all connections are made.

Attach the front panel (A) as described under “Attach 

 

‹

Front Panel”.

 

To avoid cable damage observe the cables when slid-

 

►

ing the unit into the sleeve.

Attach the frame.

 

‹

Follow these instructions to remove the unit:

 

‹

Remove the frame. 

 

‹

Insert left and right installation keys in the slots left 

 

‹

and right (the claws are now bent back).

Slide the unit out of the sleeve.

 

‹

 

Unevenness of the casing can cause the claws to 

 

►

lock. Unlock the claws with the installation keys, if 

necessary.

 

Sleeve, frame and mounting strip are not needed.

 

►

Use the threads on the side of the casing (A) to mount the 

unit on the vehicle bracket (supplied with your car). The 

holes are marked with T (for Toyota) and N (for Nissan).

A

B

C

D

B

Loosen the mounting screws for the hooks left and 

 

‹

right at the front of the unit and remove the hooks.

Mount the brackets (B) with screws on the unit (D).

 

‹

Connect line out of the external audio device to 

 

‹

IN (16) jack on the front panel.

Select playback mode for external device by repeatedly 

 

‹

pressing 

PAIR/MOD (4) until AUX is displayed.

Fit steering wheel mount for remote control
You can mount the remote control onto the inside of the 

steering wheel. Follow the steps below:

1  Rubber strap

2  Mounting bracket

3  Mounting bracket cover

4  Screws

5  Remote control

Use a Philips head screwdriver to loosen the screws (4), 

 

‹

in order to disassemble the steering wheel mount into 

the parts shown above (1-4).

Place the rubber strap around the steering wheel. 

 

‹

When doing so, select the corresponding pre-punched 

holes to fasten the mount 

securely to the steering 

wheel.

Place the cover (3) over the mounting bracket (2). Then 

 

‹

tighten the screws (4) again.

 

Before using the remote control for the first time, 

 

►

you must insert the supplied battery to make the 

remote control ready for use

The life of the supplied batteries may be shortened 

 

►

due to storage conditions.

Open the battery compartment (17) of the remote 

 

‹

control.