NEC LCD19WV LCD19WV-BK User Manual

Product codes

LCD19WV-BK

English-4

3. Connect one end of the power cord to the monitor and the other end to the power outlet. Use the Cable holder to keep the

Video Signal Cable and power cord together (Figure B.1).

4. To attach the Cable Holder:

Attach the Cable Holder on to the Base. Insert the hooks on the Cable Holder into the holes at the back of the Stand and
slide the Cable Holder downward into place (Figure B.1).

NOTE:

Please confirm that the tabs are completely secure.

NOTE:

Adjust position of cable that place under the Cable holder to avoid damage for cable or monitor.

NOTE:

Please refer to Caution section of this manual for proper selection of power cord.

5. Turn on the monitor with the front power button and the computer (Figure C.1).

Figure B.1

Cable holder

Figure C.1

Power Button

6. No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings.

For further adjustments, use the following OSD controls:

• Image Setup

• Image Position

Refer to the Controls section of this User’s Manual for a full description of these OSD
controls.

NOTE:

If you have any problem, please refer to the Troubleshooting section of this
User’s Manual.

Tilt

Grasp both sides of the monitor screen with your hands and adjust the tilt as desired
(Figure TS.1).

Remove Monitor Stand for Mounting

To prepare the monitor for alternative mounting purposes:

1. Disconnect all cables.

2. Place monitor face down on a non-abrasive surface (Figure R.1).

3. Remove the 3 screws connecting the monitor to the stand and remove the stand as indicated (Figure R.1).

The monitor is now ready for mounting in an alternative manner.

4. Connect the AC cord to the back of the monitor (Figure R.2).

5. Reverse this process to re-attach stand.

NOTE:

Use only VESA-compatible alternative mounting method.

NOTE:

Handle with care when removing monitor stand.

Figure TS.1

Input (VGA)

Power Cable