3com 4210 PWR 9-Port 3CR17341-91-ME User Manual
Product codes
3CR17341-91-ME
47
IP
V
6 A
PPLICATION
C
ONFIGURATION
Introduction to IPv6
Application
Application
IPv6 are supporting more and more applications. Most of IPv6 applications are the
same as those of IPv4. The applications supported on 3Com Switch 4210 Family
are:
same as those of IPv4. The applications supported on 3Com Switch 4210 Family
are:
■
Ping
■
Traceroute
■
TFTP
■
Telnet
IPv6 Application
Configuration
Configuration
IPv6 Ping
The ping ipv6 command is commonly used for testing the reachability of a host.
This command sends an ICMPv6 message to the destination host and records the
time for the response message to be received. For details about the ping
command, refer to “Basic System Configuration and Debugging” on page 483.
This command sends an ICMPv6 message to the destination host and records the
time for the response message to be received. For details about the ping
command, refer to “Basic System Configuration and Debugging” on page 483.
c
CAUTION: When you use the ping ipv6 command to verify the reachability of the
destination, you must specify the "-i" keyword if the destination address is a
link-local address.
destination, you must specify the "-i" keyword if the destination address is a
link-local address.
IPv6 Traceroute
The traceroute ipv6 command is used to record the route of IPv6 packets from
source to destination, so as to check whether the link is available and determine
the point of failure.
source to destination, so as to check whether the link is available and determine
the point of failure.
Table 400 Ping IPv6
To do...
Use the command...
Remarks
Ping IPv6
ping ipv6 [ -a source-ipv6 | -c count | -m interval
| -s packet-size | -t timeout ]* remote-system [ -i
interface-type interface-number ]
| -s packet-size | -t timeout ]* remote-system [ -i
interface-type interface-number ]
Required
Available in any view