Hellermann Tyton 151-00312 FKH50AVHB-HIR-BK-C1 Flat Band Cable Holder With A Special Adhesive 151-00312 Data Sheet
Product codes
151-00312
Base material
PE foam or PU foam
Temperature
range
at least up
to +105 ºC
to +105 ºC
Base material
PE foam
Temperature
range
at least -40ºC
to +60ºC
to +60ºC
C a b l e T i e s a n d F i x i n g s
C a b l e T i e M o u n t s
1.9
162
2.
3.
4.
5.
Information and installation instructions for self adhesive mounting bases
wait for a few hours before use, but has a
higher 'pull off' force than synthetic rubber.
This enables a permanent fixing lasting
months or even years. To use these
adhesives the surface must be dry, and free
of dust, oil, oxides, parting agents and
other impurities. For this the use of
isopropane/ water (50/50) is recommended.
HellermannTyton use two different types of
adhesive for self adhesive bases: acrylate
and synthetic rubber. These differ in the
operating temperature range and the 'pull
off' force of the adhesive. Synthetic rubber
has an excellent initial grip, allowing for
almost immediate use. Acrylate adhesive
has less initial grip, so there is a need to
Instructions for use
The surface must be dry, free from dust, oil, oxides,
parting agents and other impurities. The surface to
be glued should be cleaned using a clean cloth and
isopropanol /water (50/50). When using other
appropriate cleaning agents, ensure that they do
not attack the surface or leave any residues.
After cleaning allow the surface to
dry completely.
Peel off protective backing and
ensure the adhesive area is not
touched.
Press down firmly on the base for
several seconds.
Depending on the type of adhesive,
wait for several minutes (synthetic
rubber) or hours (acrylate) so that
the adhesive can bond completely
with the surface.
1.
halogenfree
halogenfree
!
!
We will be happy to send you on request an
up to date technical datasheet for whichever
adhesive you are using.
up to date technical datasheet for whichever
adhesive you are using.
Acrylate
Synthetic rubber
After cleaning allow the surface to dry
completely. Peel off the protective backing
on the self adhesive base, ensuring the
adhesive is not touched. Apply the part to
the surface and press down firmly for
several seconds.
Date of issue: April 2011