Nkk Switches Toggle switch 28 Vdc 0.1 A 1 x On/Off/On latch/0/latch 1 pc(s) B13JP Data Sheet

Indicators

Accessories

Supplement

Tactiles

Keylocks

Rotaries

Pushbuttons

Illuminated PB

Slides

Programmable

Rockers

Touch

Tilt

 

A

Toggles

General 

Specifications

Logic Level: 

  0.4VA maximum @ 28V AC/DC maximum

 

  (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)

 

  Note:  Find additional explanation of operating range in Supplement section.

Contact Resistance:   50 milliohms maximum

Insulation Resistance:  500 megohms minimum @ 500V DC

Dielectric Strength:  500V AC minimum for 1 minute minimum 

Mechanical Life:  100,000 operations minimum for On-None-On & On-Off-On  

 

  50,000 operations minimum for other circuits 

 

  50,000 operations minimum for locking lever models 

Electrical Life:  50,000 operations minimum

 

Nominal Operating Force:  Toggles A, A1, E & K with Long Paddle: 1.47N (momentary); 1.18N (maintained)

  Toggles J & H & K with Short Paddle: 2.72N (momentary); 1.84N (maintained)

 

  Toggle L: 0.59N

Contact Timing:  Nonshorting (break-before-make) 

Angle of Throw:    26°  

Toggle:  Nickel plated brass 

 

Bushing:  Carbon blended polyamide; nickel plated zinc alloy for locking levers & threaded bushing 

 

Gasket:  Nitrile butadiene rubber 

 

Case Housing:  Glass fiber reinforced polyamide 

 

Support Bracket:  Tin plated phosphor bronze

Movable Contact:  Phosphor bronze with gold plating

Stationary Contacts:  Copper alloy with gold plating 

 

Terminals:  Copper alloy with gold plating 

 Operating Temperature Range:  –30°C through +85°C (–22°F through +185°F)
 

Humidity:   90 ~ 95% humidity for 96 hours @ 40°C (104°F)

Vibration:  10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning  

 

  in 1 minute; 3 right angled directions for 2 hours

Shock:  50G (490m/s

2

) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)

Mounting Torque:  .30 ~ .45Nm (2.65 ~ 3.98 lb

•

in) for A1 actuator with threaded bushing only   

Soldering:   Wave Soldering Recommended:  See Profile A in Supplement section.

 

  Manual Soldering: See Profile A in Supplement section. 

 

Cleaning:  Automated cleaning.  See Cleaning specifications in Supplement section.

Flammability Standards:  UL94V-0 available 

  The B Series toggles have not been tested for UL recognition or CSA certification. 

 

  These switches are designed for use in a low-voltage, low-current, logic-level circuit. 

 

  When used as intended in a logic-level circuit, the results do not produce hazardous energy.