Nkk Switches Rotary switch 5 Vdc 0.1 A Switch postions 10 NDFC10P 1 pc(s) NDFC10P Data Sheet
Product codes
NDFC10P
Series ND
8mm Process Sealed DIP Rotaries
www.nkk.com
G34
Indicators
Accessories
Supplement
Tactiles
Keylocks
Pushbuttons
Illuminated PB
Slides
Programmable
Rockers
Touch
Tilt
Toggles
G
Rotaries
Electrical Capacity (Resistive Load)
Switching Rating:
100mA @ 5V DC
Nonswitching Rating: 100mA @ 50V DC
Other Ratings
Contact Resistance: 80 milliohms maximum for circuit; 30 milliohms maximum for contact point
Insulation Resistance:
1,000 megohms minimum @ 250V DC
Dielectric Strength:
250V AC minimum for 1 minute minimum
Mechanical Life:
20,000 detent operations minimum
Electrical Life:
20,000 detent operations minimum
Notes: A detent operation is one actuator position operation or stepping.
20,000 detent operations = 1,250 cycles for hexadecimal devices or 2,000 cycles for decimal
devices. A cycle is one 360° rotation.
Nominal Operating Torque: 0.006Nm
Contact Timing:
Nonshorting (break-before-make)
Materials & Finishes
Actuator:
Glass fiber reinforced polyamide
Housing:
Glass fiber reinforced polyamide (UL94V-0)
O-ring:
Nitrile butadiene rubber
Base:
Glass fiber reinforced polyamide (UL94V-0)
Movable Contact: Beryllium copper with gold plating
Stationary Contacts: Brass with gold plating
Terminals:
Brass with gold plating
Environmental Data
Operating Temperature Range: –25°C through +75°C (–13°F through +167°F)
Humidity: 90 ~ 95% humidity for 96 hours @ 40°C (104°F)
Vibration:
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
Shock:
50G (490m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Processing
Soldering: Wave Soldering Recommended: See Profile B in Supplement section.
Note: During Wave Soldering process, set the switch to the following position:
NDFR10, NDFR16, NDKR10, NDKR16: 0 position;
NDFC10, NDKC10: 7 position; NDFC16, NDKC16: F position.
Manual Soldering: See Profile B in Supplement section.
Cleaning:
Automated Cleaning. See Cleaning Specifications in Supplement section.
Standards & Certifications
Flammability Standards: UL94V-0 rated housing & base
The ND Series rotaries have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
General
Specifications