Thecus 1U4500R Leaflet

 
The 1U4500 will rotate these messages every one-two seconds on the LCD 

display. 

The USB Copy function enables you to copy files stored on USB devices such as 
USB disks and digital cameras to the 1U4500 with a press of a button. To use 
USB copy, follow the steps below: 

 

1.  Plug your USB device into an available USB port on the Front Panel. 

 

2.  In Display Mode, press the Down Button (▼). 

 

3.  The LCD will display “USB Copy?”  

 

4.  Press Enter (

↵

) and the 1U4500 will start copying USB disks connected to 

the front USB port. 

 

5.  All of data will be copied into system folder named “USBcopy”.  

During setup and configuration, the LCD will be in Management Mode. 
 
To enter into Management Mode, press Enter (

↵)

 and an “Enter Password” 

prompt will show on the LCD. 
 

At this time, the administrator has to enter the correct LCD password. System will 
check whether the correct LCD password has been entered. The default LCD 
password is “0000”. If correct password is entered, you will enter into the 
Management Mode menu. 
 

Item Description 
WAN Setting 

IP address and netmask of your WAN ports. 

LAN Setting 

IP address and netmask of your LAN ports. 

Link Agg. Setting 

Select Load Balance or Failover.  

Change Admin Passwd  Change administrator’s password for LCD operation. 
Reset to Default 

Reset system to factory defaults. 

Exit Exit 

Management Mode and return to Display Mode. 

 

You can also change your LCD password using the Web Administration 

Interface by navigating to System > Administrator Password. For 
more on the Web Administration Interface, see Chapter 4: System 
Management. 

 

From the Web Administration Interface, you can begin to setup your 1U4500 for 

use on your network. Setting up the 1U4500 typically follows the five steps 
outlined below. 

 
For more on how to use the Web Administration Interface, see Chapter 4: 

 

 
 

16