B-Tech BT7513 BT7513/S User Manual

2

INSTALLATION SAFETY INSTRUCTIONS

 
Do not attempt to install this product until all instructions and warnings have been read and properly 
understood. Please keep these instructions for future reference. 
B-Tech International Limited, its distributors and dealers are not liable or responsible for damage or 
injury caused by improper installation, improper use or failure to observe these safety instructions. In 
such cases, all guarantees will expire. 
 
General 
 
B-Tech International Ltd recommends that a professional AV installer or other suitably qualified 
person install this product. Great care must always be taken during installation as most AV equipment 
is of a fragile nature, possibly heavy and easily damaged if dropped. 
If you do not fully understand the instructions or are not sure how to install this product safely, then 
please consult a professional for advice and/or to install this product for you. Failure to mount this 
product correctly may cause serious injury or death both during installation and at any time thereafter.
Do not mount any AV equipment that exceeds the specific weight limit of the product you are 
installing. This weight limit will be clearly stated on each product and its packaging and will vary from 
product to product. 
Flat screen must be fixed to the articulating arm before mounting arm onto wall mount. 
 
Product location 
 
Please pay careful attention to where this product is located. Some walls are not suitable for 
installation. 
If located in a public or frequently populated area ensure that the product is out of the immediate 
reach of people. If any AV equipment is to be suspended over the likely path or location of people 
then great care should be taken to secure all parts of the installation from falling.  
If you install this product on drywall it must be securely fixed to a wooden stud, concrete block or other 
permanent structure behind the drywall board. Installing on drywall boards alone will not support the 
weight of most AV equipment.  
When drilling holes in walls it is essential to avoid contact with electrical cables and water or gas pipes 
contained within. Use of a good quality live wire detector and hidden object locator is therefore 
recommended. Only drill into structures when you are sure it is safe to do so. 
 
Fixing hardware 
 
It is highly recommended that all wall fixing screws be used where supplied and that the purpose of all 
other fixing hardware is fully understood. In some cases more AV equipment fixing hardware will be 
supplied to accommodate different models of equipment and set up configurations. 
The installer must be satisfied that any supplied fixing hardware is suitable for each specific 
installation. If any fixing screws or included hardware are deemed not sufficient for a safe installation 
then please consult a professional or your local hardware store. 
 
Hazard limitation 
 
When routing cables take advantage of any built in cable management features that the product might 
provide and ensure that all cables are tidy and secure. Check to see that any moving aspect of the 
product can do so unhindered by any cabling. 
Some products have moving parts and the potential to cause injury through the crushing or trapping of 
fingers or other body parts. 
Particular attention to the nature of moving parts is required especially when assembling installing and 
adjusting during set up. 
Immediately after installations double-check that the work done is safe and secure. Double-check all 
necessary fixings are present and are of ample tightness. 
It is recommended that periodic inspections of the product and its fixing points are made as frequently 
as possible to ensure that safety is maintained. If in doubt consult a professional AV installer or other 
suitably qualified person.