Thecus N5200B PRO Leaflet

 

 
 

45 

The N5200PRO supports two Gigabit 

Ethernet ports for higher service availability. 
To configure these ports, choose LAN from 
the Network menu, and the LAN 

Configuration screen appears. Press Apply 
to save your changes. 

 
 

 
 

 
 
 

 
 

 
 

Item Description 
MAC Address 

Displays the MAC address of the LAN interface. 

IP 

Specifies the IP address of the LAN interface. 

Netmask 

Specifies the Network Mask of the LAN interface. 

Jumbo Frame Support 

Enable or disable Jumbo Frame Support on the LAN interface. 

 
 
 

 
 

 

A DHCP server can be configured to assign IP addresses to devices connected to 

the LAN port. To configure these ports, choose LAN from the Network menu. 
 

Item Description 
DHCP Server 

Enable or disable the DHCP server to automatically assign IP 

address to PCs connected to the LAN interface. 

Start IP 

Specifies the starting IP address of the DHCP range. 

End IP 

Specifies the ending IP address of the DHCP range. 

DNS Server 

Displayed the DNS server IP address. 

 

 
 
 

 
 

Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo 

Frame and you will not be able to connect to your N5200PRO after 

Jumbo Frame is turned on. If this happens, turn off the N5200PRO. 

Then, power on the N5200PRO and immediately press and hold the 

Reset button on the back of the unit for 10 seconds. This will reset 

your network settings, password, and turn off Jumbo Frame Support. 

Before enabling Jumbo Frame Support, please make sure your network 

equipment supports Jumbo Frame. If your equipment is incompatible, 

you might not be able to connect to your N5200PRO. In this case, you 

have to reset the system back to default by the holding down front 

panel reset button for 5 seconds during boot up process. 

The IP Segment of WAN and LAN should not overlap. 

The IP address of the LAN interface should not be in the range of the 

Start IP address and End IP address.