Thecus 1U4500S Leaflet
The 1U4500 will rotate these messages every one-two seconds on the LCD
display.
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as
USB disks and digital cameras to the 1U4500 with a press of a button. To use
USB copy, follow the steps below:
USB disks and digital cameras to the 1U4500 with a press of a button. To use
USB copy, follow the steps below:
1. Plug your USB device into an available USB port on the Front Panel.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display “USB Copy?”
4. Press Enter (
↵
) and the 1U4500 will start copying USB disks connected to
the front USB port.
5. All of data will be copied into system folder named “USBcopy”.
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
To enter into Management Mode, press Enter (
↵)
and an “Enter Password”
prompt will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is “0000”. If correct password is entered, you will enter into the
Management Mode menu.
check whether the correct LCD password has been entered. The default LCD
password is “0000”. If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item Description
WAN Setting
WAN Setting
IP address and netmask of your WAN ports.
LAN Setting
IP address and netmask of your LAN ports.
Link Agg. Setting
Select Load Balance or Failover.
Change Admin Passwd Change administrator’s password for LCD operation.
Reset to Default
Reset to Default
Reset system to factory defaults.
Exit Exit
Management Mode and return to Display Mode.
NOTE
You can also change your LCD password using the Web Administration
Interface by navigating to System > Administrator Password. For
more on the Web Administration Interface, see Chapter 4: System
Management.
more on the Web Administration Interface, see Chapter 4: System
Management.
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your 1U4500 for
use on your network. Setting up the 1U4500 typically follows the five steps
outlined below.
outlined below.
For more on how to use the Web Administration Interface, see Chapter 4:
System Management >
16