Technoline WS 6010 Wireless Solar Thermometer/ Hygrometer and Clock WS 6010 Data Sheet
Product codes
WS 6010
3
Normal Operation Mode:
•
This mode occurs when the battery voltage is higher than 2.5V.
•
The transmitter will measure and transmit the temperature and humidity
data to the Solar Station every 5 seconds.
data to the Solar Station every 5 seconds.
•
If a dark environment is detected, it will measure and transmit the
temperature every 10s.
temperature every 10s.
•
If the battery voltage is dropped lower than 2.8V, it will measure and
transmit the temperature every 10s
transmit the temperature every 10s
•
If battery voltage is dropped lower than 2.4V, will go into Idle mode.
•
If the solar transmitter is placed into a dark environment for 72 hours, will
goes into Stop mode.
goes into Stop mode.
•
If the user cover the solar cell for 10 seconds and press the reset button,
"StP" will be displayed on the LCD. Then the transmitter enters STOP
mode.
"StP" will be displayed on the LCD. Then the transmitter enters STOP
mode.
Idle Operation Mode:
•
This mode is occurred when the battery voltage is dropped lower than
2.4V
2.4V
•
LCD is turned off
•
Does not perform temperature measurement and transmission
•
If battery voltage is raised higher than 2.5V, will go into Normal mode
•
If the solar transmitter is placed into a dark environment for 72 hours, will
goes into Stop mode.
goes into Stop mode.
Stop Operation Mode:
•
This mode is occurred when the solar transmitter is placed into a dark
environment for 72 hours or the user cover the solar cell for 10 seconds
and press the RESET button
environment for 72 hours or the user cover the solar cell for 10 seconds
and press the RESET button
•
The transmitter is in a standby state. Without perform any operation and
LCD is off
LCD is off
•
Under a bright condition, press the reset button to wake up the transmitter
into normal operation mode (battery voltage is higher than 2.5V). ). If the
battery is lower than 2.4V, a “Lo” icon will be shown in the LCD for a while.
Then the transmitter will enter the idle mode.
into normal operation mode (battery voltage is higher than 2.5V). ). If the
battery is lower than 2.4V, a “Lo” icon will be shown in the LCD for a while.
Then the transmitter will enter the idle mode.
•
The most power saving mode.