Philips Hair clipper Black QC5770/80 Data Sheet

  2 

 Switch on the appliance.

  3 

 Hold the appliance with the cutting unit pointing 

upwards and make downward strokes with the 

precision trimmer (the narrow side of the cutting 

unit).

Be careful, the trimmer removes every hair it touches.

Clean the appliance every time you have used it.
Never use scouring pads, abrasive cleaning agents or 

aggressive liquids such as alcohol, petrol or acetone to 

clean the appliance. 
Only clean the appliance and the adapter with the 

cleaning brush supplied.

  1 

 Make sure the appliance is switched off and 

disconnected from the mains.

  2 

 Pull the comb off the appliance (Fig. 10).

  3 

 Clean the cutting unit with the cleaning brush 

supplied. Also brush away any hairs that have 

collected in the openings under the cutting 

unit (Fig. 12).

  1 

 Put the appliance in the storage case supplied.

  2 

 Store the appliance in a safe and dry place. 

 - Do not throw away the appliance with the normal 

household waste at the end of its life, but hand it in 

at an official collection point for recycling.  (Fig. 13)

 - The built-in rechargeable battery contains substances 

that may pollute the environment. Always remove 

the battery before you discard and hand in the 

appliance at an official collection point. Dispose of 

the battery at an official collection point for batteries. 

If you have trouble removing the battery, you can 

also take the appliance to a Philips service centre. 

The staff of this centre will remove the battery for 

you and will dispose of it in an environmentally safe 

way (Fig. 14).
Removing the rechargeable battery

Only remove the rechargeable battery if it is completely 

empty.
Do not connect the appliance to the mains again after 

you have opened it.

  1 

 Disconnect the appliance from the mains and let 

the appliance run until the motor stops.

  2 

 Pull the cutting unit off the appliance.

  3 

 To remove the front panel, insert a screwdriver 

between the front panel and the appliance (Fig. 15).

  4 

 Undo the screw behind the front panel (Fig. 16).

  5 

 Insert a screwdriver between the front housing and 

the back housing of the appliance (Fig. 17).

  6 

 Remove the entire front housing (Fig. 18).

  7 

 Undo the four screws that fasten the printed circuit 

board (Fig. 19).

  8 

 Pull out the printed circuit board with rechargeable 

battery (Fig. 20).

  9 

 Cut the wires that connect the printed circuit 

board with rechargeable battery to the 

motor (Fig. 21).
Guarantee and service

If you need service or information or if you have a 

problem, please visit the Philips website at  

www.philips.com or contact the Philips Consumer 

Care Centre in your country (you find its phone number 

in the worldwide guarantee leaflet). If there is no 

Consumer Care Centre in your country, go to your local 

Philips dealer.

3

4222.002.8067.1