Intel Desktop Board D915PSY BOXD915PSYL User Manual
Product codes
BOXD915PSYL
Product Description
1.9 I/O Controller
The I/O controller provides the following features:
• Two serial ports (Serial Port B is optional)
• One parallel port with Extended Capabilities Port (ECP) and Enhanced Parallel Port
• Two serial ports (Serial Port B is optional)
• One parallel port with Extended Capabilities Port (ECP) and Enhanced Parallel Port
(EPP) support
• Serial IRQ interface compatible with serialized IRQ support for PCI Conventional bus systems
• PS/2-style mouse and keyboard interfaces
• Interface for one 1.44 MB or 2.88 MB diskette drive
• Intelligent power management, including a programmable wake-up event interface
• PCI Conventional bus power management support
• PS/2-style mouse and keyboard interfaces
• Interface for one 1.44 MB or 2.88 MB diskette drive
• Intelligent power management, including a programmable wake-up event interface
• PCI Conventional bus power management support
The BIOS Setup program provides configuration options for the I/O controller.
1.9.1 Serial
Ports
The Desktop Board can support up to two serial port connectors. Serial port A is located on the
back panel. Serial port B (optional) is accessible using a connector on the component side of board.
The serial ports support data transfers at speeds up to 115.2 kbits/sec with BIOS support.
back panel. Serial port B (optional) is accessible using a connector on the component side of board.
The serial ports support data transfers at speeds up to 115.2 kbits/sec with BIOS support.
For information about
Refer to
The location of the serial port A connector
Figure 17, page 64
The location of the serial port B connector on the D915PGN board
Figure 18, page 66
The location of the serial port B connector on the D915PSY board
Figure 19, page 68
The signal names of the serial port B connector
Table 24, page 70
1.9.2 Parallel
Port
The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS Setup
program to set the parallel port mode.
program to set the parallel port mode.
For information about
Refer to
The location of the parallel port connector
Figure 17, page 64
1.9.3 Diskette Drive Controller
The I/O controller supports one diskette drive. Use the BIOS Setup program to configure the
diskette drive interface.
diskette drive interface.
For information about
Refer to
The location of the diskette drive connector on the D915PGN board
Figure 18, page 66
The location of the diskette drive connector on the D915PSY board
Figure 19, page 68
29