Voltcraft BS-100XIP Endoscope BS-100XIP Data Sheet

19

•  If it is no longer possible to operate the product safely, take it out of operation and 

protect it from any accidental use. Safe operation can no longer be guaranteed if the 

product:

 - is visibly damaged, 
 - is no longer working properly, 
 - has been stored for extended periods in poor ambient conditions or 
 - has been subjected to any serious transport-related stresses.

•  Never switch on the device immediately after it has been taken from a cold to a warm 

environment. Under adverse conditions, the resulting condensation could destroy the 

device. Allow the device to reach room temperature before switching it on.

•  Attention, LED light: Do not look directly into the LED light! Do not look into the beam 

directly or with optical instruments!

•  Observe also the additional safety instructions in each chapter of these operating 

instructions as well as in the operating instructions of the connected devices.

•  Correct polarity must be observed while inserting the batteries.
•  Batteries should be removed from the device if it is not used for a long period of time to 

avoid damage through leaking. Leaking or damaged batteries might cause acid burns 

when in contact with skin, therefore use suitable protective gloves to handle corrupted 

batteries.

•  Batteries must be kept out of reach of children. Do not leave the battery lying around, 

as there is risk, that children or pets swallow it.

•  All the batteries should be replaced at the same time. Mixing old and new batteries in 

the device can lead to battery leakage and device damage.

•  Batteries must not be dismantled, short-circuited or thrown into fire. Never recharge 

non-rechargeable batteries. There is a risk of explosion.

•  Consult an expert when in doubt about operation, safety or connection of the device.
•  Maintenance, modifications and repairs are to be performed exclusively by an expert 

or at a qualified shop.

If you are not sure about the correct connection or use, or if questions arise which are not covered 

by these operating instructions, please do not hesitate to contact our technical support or another 

qualified specialist.
Voltcraft®, Lindenweg 15, D-92242 Hirschau, Tel. +49 180/586 582 7.