Reely Quadrocopter configuration kit 205499 205499 Data Sheet
Product codes
205499
Manual Configuration Kit QuadroCopter
Page 1
The manufacturer assumes no liability for incorrectly set or user
defined parameters!
defined parameters!
1. Introduction
The configuration tool helps the user to adapt the Quadrocopter behavior to his own needs. The program can
•
make a firmware update that offers new flight features and fixes possible problems and
•
change the flight parameter of the Quadrocopter to his own desires and transfer them to the hardware.
If there is a new firmware available, it can be found on the download site of the manufacturer. To communicate
with the Quadrocopter, a serial connection must be established by using a interface cable, that is available
seperately. Then the QudaroCopter should be brought to the bootloader mode. Details how to enter the
bootloader are described in the user manual of the Quadrocopter. If the configuration tool is used for the first time,
the correct serial interface should be set in the Configuration window.
with the Quadrocopter, a serial connection must be established by using a interface cable, that is available
seperately. Then the QudaroCopter should be brought to the bootloader mode. Details how to enter the
bootloader are described in the user manual of the Quadrocopter. If the configuration tool is used for the first time,
the correct serial interface should be set in the Configuration window.
You can open the configuration window by a click on "Configuration".
The specific possibilities of the configuration tool are explained in more detail in the next chapters.
•
General Configuration
•
Remote Control
•
Flight Leveling
•
Gas
•
Firmware Update
2. General Configuration
You can connect the Quadrocopter with the interface cable to the PC. Therefore you have to plug in the interface
cable to the Quadrocopter like shown in the picture below. The USB connector type end of the cable is pluged
into the USB interface on the PC.
cable to the Quadrocopter like shown in the picture below. The USB connector type end of the cable is pluged
into the USB interface on the PC.
Take care about using the interface cable in the correct direction.
Otherwise no communication can be established!
Otherwise no communication can be established!