Futaba 6J F4103 Data Sheet

connections so the values can be set closer to 100%.  When the EPA is set to 100%, the maximum servo 
throw for channels 1, 2, 3, and 4 is approximately 400 and approximately 550 for channels 5 and 6.

Note:_{! |'### # !  #+ !
#   #   +"! #
throws will also change.  Additionally, it is possible for the dual rates, mixings, etc. to also overthrow (or 
overdrive) the end point adjustments.  It is important to test these functions to ensure that binding does not 
occur.

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.

3) Press either the MODE key OR the END key to scroll through the function menus.  

Continue pressing the MODE or END key until the end points (EPA) menu appears 
on screen. 

4) The channel number being adjusted, along with a position indicator will appear on the left side on the 

screen.  The current end points will be noted beneath the percentage symbol on the right side of the screen. 

5) To change the RIGHT aileron throw move the aileron stick to the right, then push the DATA INPUT lever 

up or down to change the value and the throw accordingly.

6) Move the stick to the left and use the DATA INPUT lever to change the LEFT aileron throw.

7) Press the SELECT key to display the next channel to be adjusted.  

8) Repeat steps 1-6 for all remaining channels as desired.  Notice that moving the stick (or switch) from one 

 # !# ! '{|#!

;# }{ |~; *## ;#
Three of them are used for adjusting the neutral stick position of the aileron, elevator and rudder servos, 
respectively.  The fourth trim is for setting the idle rpm of the engine when the throttle stick is all the way 
down.  

;   "!   =#!!# {|
} '##=  ##~•  + '## = 
{!|  _!# ! !### '#=