Futaba 6J F4103 Data Sheet

6) Press the SELECT button to bring up the point two (2) pitch curve adjustments.  Again, use the DATA 

INPUT lever to adjust the values accordingly.

7) Repeat the steps above as desired for the remaining three points on the pitch curve.

8) Press and hold the END button to exit the programming mode.

#&#  {|&  ! '
pitch inputs.  This mixing assists in compensating for the rotation of the helicopter caused by the increased 
torque.  The T6J transmitter allows for a high rate and a low rate adjustment for the revolution mixing.

Note: If using a heading hold/AVCS gyro, only use the revolution mixing when this gyro is in the normal 
mode.  Do NOT use revolution mixing with a heading hold/AVCS gyro when it is in the heading-hold/AVCS 
mode.

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.

3) Press either the MODE key OR the END key to scroll through the function menus.  

Continue pressing the MODE or END key until the revolution mixing (REVO) menu 
appears on screen.

4) The right side of the LCD should indicate that the revolution mixing is inhibited, 

as denoted by the flashing INH.  Activate the revolution mixing by pressing and 
#  ˆ*;* [<‚; # !'  ; [‹  # + =  !# 
prior to changing to ON.  

5) Push the SELECT key to bring up the low rate (as indicated by the down arrow on 

the left side of the LCD screen).     

6) To adjust the value, press the DATA INPUT lever either upward or downward until 

the desired value is achieved. 

7) Press the SELECT key once again to access the revo mixing adjustments for the high side.  The up arrow 

on the left side of the screen indicates that it is the high side that will be adjusted.  

8) To adjust the value, press the DATA INPUT lever either upward or downward until the desired value is 

achieved.