Jeti Hendheld RC 2.4 GHz No. of channels: 8 80001586 User Manual

Product codes

80001586

computer radio control system

Carefully remove both control stick assemblies. Gently pull in

your direction (toward the transmitter back side). This upgrade

will be done outside of the transmitter case.

Unscrew the upper part of the stick assembly (anticlockwise).

Insert the connecting wires through the hollow opening of the

transmitter stick.

Adjust length of the stick to suit your flying style. (See 4.3)

Disconnect the control stick assembly wires from the Tx board.

(3 wires

)

X, Y, S

Remove the stick assembly connecting wires from their holders.

Remove both machine installation screws for each of the

control stick assemblies.

After installation of the optional stick ends with switch or
button make sure that while adjusting the stick length you
observe the wires that pass through the stick shaft and
through the gimbal opening in order to prevent damaging
the connecting cables. The safest method is to remove the
small set-screw from the side of the stick housing to allow
the switch or knob internals to remain stationary while you
rotate the stick housing for height adjustment.

Pass the switch wires through the same gimbal opening as the

hall sensor cable (through the center of the gimbal assembly).

10.

Next insert wire ends through the opening of the printed circuit

board and solder them to the matching soldering points in such

a way that the same color wires lay on the top of each other.

11.

Carefully move transmitter sticks to their full outside positions

in order to make sure that you have sufficient wire length and, if

needed, adjust accordingly. The connecting cables for

all moving parts of the unit should have sufficient length in

order not to be exposed to any mechanical damage and any

bending stresses.

Note:

X Y S