Jeti 4-channel receiver 2.4 GHz FHSS with Connector system JR 80001221 User Manual
Product codes
80001221
computer radio control system
EN
6.2 Measure
Measure: enables read out of measured data of the maximum,
minimum and actual receiver voltage.
minimum and actual receiver voltage.
Volt Min / Act / Max- the receiver is checking the supply voltage
and indicates limit values and extremes which
occurred during operation; at the same time it also shows the actual
receiver voltage. Without switching on the paired
transmitter the values MAX and MIN will not change, only the value
of the actual voltage ACT will be updated. In order
to delete values MAX and MIN, keys L (arrow left) and R (arrow right)
must be pressed simultaneously.
and indicates limit values and extremes which
occurred during operation; at the same time it also shows the actual
receiver voltage. Without switching on the paired
transmitter the values MAX and MIN will not change, only the value
of the actual voltage ACT will be updated. In order
to delete values MAX and MIN, keys L (arrow left) and R (arrow right)
must be pressed simultaneously.
6.3 Main Setting
Fail Safe - switches the Fail Safe function on and off. If the Fail Safe
function is disabled, there are no signals generated on receiver
outputs in case of signal loss. If the Fail Safe function is activated,
the receiver outputs are generated according your your individual
channel setup selections in case of signal loss. („out off“, „hold“,“ fail
safe“)
function is disabled, there are no signals generated on receiver
outputs in case of signal loss. If the Fail Safe function is activated,
the receiver outputs are generated according your your individual
channel setup selections in case of signal loss. („out off“, „hold“,“ fail
safe“)
Signal Fault Delay - the time interval, from when the receiver
detects signal loss to when the fail safe control throws are initiated.
After the expiration of this time, the receiver outputs will transition
to your selected individual channel outputs.
detects signal loss to when the fail safe control throws are initiated.
After the expiration of this time, the receiver outputs will transition
to your selected individual channel outputs.
Volt ACT/ALARM: the first item displays the actual receiver supply