Unold 48016 Data Sheet

24

1.  Prepare the appliance as descri-

bed in the section “Preparing the 

appliance for operation” .

2.  Open the cover of the appliance. 

Check to make sure the seal is 

inserted properly. If there are any 

foreign objects such as crumbs on 

the seal, they have to be removed, 

since otherwise no vacuum can be 

created.

3.  Fill the bag with the food to be 

vacuumed. For optimal results, 

the bag should not be too full. 

Leave about 8 cm between the 

contents and the edge of the bag.

4.  Place the open end of the bag in 

the middle of the vacuum packing 

chamber.

5.  Close the cover and press the two 

catches on the right and left of 

the appliance inward at the same 

time.

6.  Press the button “Vacuum & 

Seal“. The indicator lamp lights 

up red to indicate that vacuum 

packing is in progress.

7.  When the optimal vacuum result 

has been achieved, the bag is 

sealed: the indicator lamp shows 

this by lighting orange. 

8.  The appliance starts with sealing, 

the vacuum pump no longer 

works.

9.  When the process is completed, 

the indicator lamp lights green 

and the two catches on the appli-

ance open automatically.

10.  Now open the lid and remove the 

bag.

11.  The vacuum packing process is 

completed and the food in the 

bag is vacuum sealed.

12.  If you only wish to seal the bag 

without a vacuum, just press the 

button “Seal Now”.

13.  If you wish to interrupt the vacuum 

packing process, press the button 

“Vacuum & Seal” again.

14.  Always check whether the vacuum 

result meets your requirements 

and ensure that the sealing strip 

is complete and flawless.

1.  Prepare the appliance as descri-

bed in the section “Preparing the 

appliance for operation”.

2.  Open the cover of the appliance. 

Check to make sure the seal is 

inserted properly. If there are any 

foreign objects such as crumbs on 

the seal, they have to be removed, 

since otherwise no vacuum can be 

created.

3.  Cut the required amount of film 

from the roll. Caution: Add at 

least 7.5 cm for vacuum packing. 

If you wish to reuse the bag, you 

have to add even more: allow 

2.5 cm for each vacuum packing 

process.

4.  Place one open end of the film 

over the sealing gasket. You do 

not have to insert this end of 

the bag into the vacuum packing 

chamber, since the bag first has 

only to be sealed, without crea-

ting a vacuum.

5.  Close the cover and press the two 

catches on the right and left of 

the appliance inward at the same 

time.

6.  Press the button „Seal Now“. The 

indicator lamp lights up orange 

to indicate that the appliance is 

sealing. The vacuum pump is still 

off.

7.  After a short time the indicator 

lamp lights up red, the appli-

ance works for another approx. 

2 seconds.

8.  Once the process is completed, 

the cover of the appliance opens 

slightly and the indicator lamp 

lights green.

9.  Open the lid and remove the bag.