Toolcraft LDM-70BT Laser rangefinder Reading range (max.) 70 m 1095733 User Manual

56

5.  The calculated area is shown in the lower line.
6.  Leave area measurement mode by pushing the button   

(depending on the display, you may need to push the button several 

times).

Delete the measurements by pushing the button  . Then repeat 

the measurement. 

1.  Following the instructions contained in the chapter "i) Area 

measurement" on page 54, carry out an area measurement.

2.  Push the button    (15) for addition or the button    (7) for 

subtraction.

3.  Push the button   and carry out a second area measurement.
4.  The sum/difference of both areas is shown in the lower line.
5.  Add/subtract further areas.
6.  Leave area measurement mode by pushing the button   

(depending on the display, you may need to push the button several 

times).

Delete the measurements by pushing the button  . Then repeat 

the measurement.

1.  Turn on the device.
2.  Push the button   (16) until the display shows   (cube). The 

longer side of the cube flashes.

3.  Push the button   to activate the target laser. Push the button   

again to measure the length of the cube. The measured value is 

moved to the upper line and the width of the cube flashes.

4.  Repeat the above steps to measure the width and height of the cube.
5.  After you measure the height of the cube, the calculated volume is 

shown in the lower line of the display.