H Tronic 230 V / ACCharger C5ForNiCd, NiMH, Li-ion, LiPolymer, SLA, Lead-acid, Lead acid membraneRechargeable batteriesM 1242465 User Manual

Product codes
1242465
Page of 26
 
 
Therefore, check the charging process at regular intervals and, in the event of any irregularities 
(excessive heating of the battery, strong liberation of gas), immediately pull out the mains plug and 
disconnect the battery from the charger. 
 When you are not using the charger or when you are cleaning it, pull out the mains plug and disconnect 
the unit from the battery. Never pull on the mains lead, instead grasp the mains plug. 
 Do not dismantle the charger and do not attempt to make any repairs. The charger contains no parts 
that can be replaced or repaired by you. 
 If the unit starts to smoke, gives off a burning smell or makes strange noises, immediately disconnect 
from the mains supply and seek advice from your specialist dealer. 
 
In the event of  any damages  resulting from failure to follow these operating instructions the  claim 
under guarantee is discharged. We accept no liability for consequential damages! 
In the event of property and personal damages resulting from improper handling or failure to follow 
safety advice, we accept no liability. In such cases any claim under guarantee is extinguished! 
 
 
The following safety and hazard advice serves not only to protect your health but also to protect the 
unit. Please read through the following points carefully: 
 
•  For reasons of safety and admissibility (CE) the unauthorised conversion and/ or alteration of the product is not 
permitted. 
 
•  For voltage/power supply, the charger must be connected via the mains cable to the public power supply 
using the correct mains plug (230V~/50Hz). 
 
•  The product must only be used in dry, closed interiors. It must not become damp or wet. Avoid direct 
sunlight, high heat, (>35°C) or cold (<0°C). The same applies to the connected battery. 
 
•  For example, do not place any containers, vases or plants on or next to this charger and the battery. Liquids 
could get into the casing and thereby compromise electrical safety. Moreover, there is a great danger of 
fire or a life-threatening electric shock! 
    In this case, immediately disconnect the product from the mains power supply (first switch the mains off at 
 the socket, then pull the mains plug out of the mains socket!). Then disconnect the battery from the charger. 
  
   The battery must be dried completely or cleaned on the outside. Do not use the charger anymore; bring it 
 to a specialist workshop. 
 
•  The product is not a toy. It is not suitable for children. Be particularly vigilant when children are present! Children 
may attempt to stick objects through the openings in the casing. This causes damage to the unit and, 
furthermore, there is danger to life through electric shock!  
   The product must only be set up, operated or stored in a place where it is not accessible to children.  Children 
 could alter settings or short-circuit the battery/battery pack, which can cause an explosion. Mortal danger! 
 
•   Do not leave the packaging material lying around unattended. This could become a dangerous toy for children!  
•   The product is only suitable for charging lead-acid, lead-gel, NiCd, NiMH, Pb, Li-ion and Li-polymer 
 batteries. 
•   Pay close attention to the battery manufacturer’s specifications. 
•   Non-rechargeable batteries must not be charged! Danger of explosion! 
 
•   Never operate the product unattended. Despite the comprehensive and multiple safety switches, 
 malfunctions or problems cannot be excluded during battery charging. 
 
•   Only operate the product in a moderate climate, never in a tropical climate. Pay attention to the chapter 
‘Technical data' for permissible environmental conditions. 
 
 
 
 
 
 
 
4. Safety advice