Cep Terminals 6201 GSM Remote Switch Control Module 6201 Data Sheet
Product codes
6201
CEP AG
Revision 1.4
_________________________________________________________________________________
__________________________________________________________________________________________
Page 12 of 32
3.2 Switching OFF the modem
There are two ways to switch off (power down) the modem as described below:
use the
“AT^SMSO” command
EMERG_OFF to high level for t < 1s
A delay of up to 10s is experienced as the modem logs off the network
3.3 Operating states / LEDs
3.3.1
Power up LED (green LED in the middle)
The modem has a green power up LED, as depicted below, which is used to indicate
various operating states. These states are described in following table.
Operating state of CT63 Terminal
Power up LED
state
state
Device off
Permanently off
net search / not registered /
Fast blinking
registered full service
Slow blinking
A call is active
Permanently on
4 Power consumption
The following table shows you the power consumption of the CT63 / in different
modes:
CT63 Terminal
[mA] @ 5V
[mA] @ 12V [mA] @ 24V [mA] @ 32V
CT63 off (DTR low, no TO-IN)
0,04
0,11
0,22
0,29
CT63 idle mode
24,0
11,1
6,2
5,5
CT63 low power mode
3,0
1,1
1,0
0,9