Microchip Technology ICD 3 In-Circuit Debugger DV164035 DV164035 User Manual
Product codes
DV164035
MPLAB
®
ICD 3 In-Circuit Debugger User’s Guide
DS51766A-page 82
© 2008 Microchip Technology Inc.
10.6.2
Modular Cable and Connector
For standard communications, a modular cable connects the debugger and the target
application. The specifications for this cable and its connectors are listed below.
application. The specifications for this cable and its connectors are listed below.
10.6.2.1
MODULAR CONNECTOR SPECIFICATION
• Manufacturer, Part Number – AMP Incorporated, 555165-1
• Distributor, Part Number – Digi-Key, A9031ND
The following table shows how the modular connector pins on an application corre-
spond to the microcontroller pins. This configuration provides full ICD functionality.
spond to the microcontroller pins. This configuration provides full ICD functionality.
FIGURE 10-2:
MODULAR CONNECTOR PINOUT OF TARGET BOARD
10.6.2.2
MODULAR PLUG SPECIFICATION
• Manufacturer, Part Number – AMP Incorporated, 5-554710-3
• Distributor, Part Number – Digi-Key, A9117ND
10.6.2.3
MODULAR CABLE SPECIFICATION
• Manufacturer, Part Number – Microchip Technology, 07-00024
10.7
ICD 3 TEST INTERFACE BOARD
This board can be used to verify that the debugger is functioning properly. To use this
board:
board:
Modular
Connector Pin
Microcontroller
Pin
6
LVP
5
RB6
4
RB7
3
Ground
2
V
DD
Target
1
V
PP
1
6
Bottom view of Modular Connector
Pinout on Target Board
1 6
Front view of Modular Connector
on Target Board
Pin 1
8.00”
Pin 6