Microchip Technology Universal Device Programmer DV007004 DV007004 User Manual
Product codes
DV007004
© 2006 Microchip Technology Inc.
DS51464C-page 99
MPLAB
®
PM3
USER’S GUIDE
Appendix A. Hardware Specifications
A.1
INTRODUCTION
This appendix describes MPLAB PM3 to PC connections, programmer hardware and
socket module hardware. Contents of this appendix include:
• Connecting to a PC via the Serial Port
• Programmer Specifications
• ICSP Hardware Specifications
• Socket Module Specifications
socket module hardware. Contents of this appendix include:
• Connecting to a PC via the Serial Port
• Programmer Specifications
• ICSP Hardware Specifications
• Socket Module Specifications
A.2
CONNECTING TO A PC VIA THE SERIAL PORT
MPLAB PM3 interfaces to the PC via a standard RS-232 port with a DB9 connector.
The unit defaults to a 57.6K baud rate.
Serial port communications are as follows:
• 57.6K (default) or 9.6K baud (PROCMD only)
• 8 data bits, 1 stop bit, no parity
• Hardware flow control
Table A-1 gives the data for connecting the MPLAB PM3 programmer (9-pin
straight-through) to a 25-pin serial port. Connect the corresponding terminals indicated
on each line of the table.
The unit defaults to a 57.6K baud rate.
Serial port communications are as follows:
• 57.6K (default) or 9.6K baud (PROCMD only)
• 8 data bits, 1 stop bit, no parity
• Hardware flow control
Table A-1 gives the data for connecting the MPLAB PM3 programmer (9-pin
straight-through) to a 25-pin serial port. Connect the corresponding terminals indicated
on each line of the table.
TABLE A-1:
PC HOST TO MPLAB
®
PM3 SIGNALS
25-pin (PC-Host)
9-pin (MPLAB PM3)
2
TX
2
RX
3
RX
3
TX
20
DTR
4
DTR
7
Common
5
Common
6
DSR
6
+5 volts (pulled up)
4
RTS
7
CTS
5
CTS
8
RTS