Microchip Technology Universal Device Programmer DV007004 DV007004 User Manual
Product codes
DV007004
MPLAB
®
PM3 User’s Guide
DS51464C-page 12
© 2006 Microchip Technology Inc.
2.2.2
USB Driver Installation
Install MPLAB IDE first. The USB driver installation instructions will pop up at the end
of MPLAB IDE installation. Follow those instructions to install the USB driver.
The instructions are in the MPLAB IDE installation directory under:
of MPLAB IDE installation. Follow those instructions to install the USB driver.
The instructions are in the MPLAB IDE installation directory under:
MPLAB PM3\Drivers\instr.htm
where instr.htm depends on your Personal Computer (PC) OS:
• ddpm398.htm – Windows 98
• ddpm3me.htm – Windows ME
• ddpm3.htm – Windows 2000/XP
• ddpm398.htm – Windows 98
• ddpm3me.htm – Windows ME
• ddpm3.htm – Windows 2000/XP
2.3
INSTALLING MPLAB PM3 HARDWARE
IMPORTANT: Do not allow the Windows OS to pick a USB driver. Follow the procedure
specified in Section 2.2.2 “USB Driver Installation”.
The MPLAB PM3 hardware is simple to set up:
• If you are using MPLAB IDE:
specified in Section 2.2.2 “USB Driver Installation”.
The MPLAB PM3 hardware is simple to set up:
• If you are using MPLAB IDE:
- Attach the communications cable.
- Connect the power supply to MPLAB PM3.
- Install the socket module (or attach the ICSP cable).
- Connect the power supply to MPLAB PM3.
- Install the socket module (or attach the ICSP cable).
• If you are using MPLAB PM3 in Stand-Alone mode:
• If you are using the MPLAB PM3 Card in MPLAB PM3:
- Insert the MPLAB PM3 Card into the SD-MMC port on the back of the
programmer.
2.3.1
Installing the Communications Cable
MPLAB PM3 provides communications with the host PC via an RS-232 9-pin D type
connector or a USB connector. See Figure 2-1 for communication port locations.
MPLAB PM3 is supplied with two 6-foot data cables: one with DB-9 connectors and one
with USB connectors. All lines on the serial cable are wired straight through. The serial
cable is NOT a null modem cable.
connector or a USB connector. See Figure 2-1 for communication port locations.
MPLAB PM3 is supplied with two 6-foot data cables: one with DB-9 connectors and one
with USB connectors. All lines on the serial cable are wired straight through. The serial
cable is NOT a null modem cable.
FIGURE 2-1:
BACK VIEW OF MPLAB
®
PM3
NOTICE
Do not allow the Windows OS to pick a USB driver. MPLAB PM3 will not work with
this driver. You must follow the procedure specified at MPLAB IDE software installa-
tion to set up the USB driver or to fix an improper driver installation.
this driver. You must follow the procedure specified at MPLAB IDE software installa-
tion to set up the USB driver or to fix an improper driver installation.
I
O
Power On Power Off
Power Input
USB Port
USB
RS-232
Serial Port
PWR
SD-MMC
Secure Digital/
Multi-Media Card Port