Ryobi RLT7038 5133001243 Data Sheet

English

FR

DE

ES

IT

NL

PT

DA

SV

FI

NO

RU

PL

CS

HU

RO

LV

LT

ET

HR

SL

SK

BG

When using the product, the safety rules must be 
followed. For your own safety and that of bystanders, 
please read these instructions before operating the 
product. Please keep the instructions safe for later use.

This appliance is not intended for use by persons 
(including children) with reduced physical, sensory or 
mental capabilities, or lack of experience and knowledge, 
unless they have been given supervision or instruction 
concerning use of the appliance by a person responsible 
for their safety. Children should be supervised to ensure 
that they do not play with the appliance.

■

Never allow children or people unfamiliar with these 
instructions to operate the trimmer.

■

Keep the area clear of all bystanders, children and pets 
while trimming. Stop machine if anyone enters the area.

■

Never operate the trimmer when you are tired, ill or 
under the influence of alcohol, drugs or medicine.

■

Use the trimmer for cutting grass and light weeds only. 
Do not use for any other purpose.

■

Keep in mind that the operator or user is responsible 
for accidents or hazards occurring to other people or 
their property.

■

Avoid unintentional starting. Always check that the 
switch is in Off position before plugging in the tool to the 
power supply. Do not carry a plugged in tool with your 
finger on the switch.

■

Electrical power should be supplied via a residual 
current device (RCD) with a tripping current of not more 
than 30 mA.

■

Before use, examine the power cord or extension cable 
for damage. If there are signs of damage, it must be 
replaced by a qualified service technician.

■

Do not use the trimmer if the electric cables are 
damaged or worn.

■

If the power cord or extension cable becomes 
damaged during use, disconnect from the power supply 
immediately. Do not touch the electric cables until the 
power supply has been disconnected. Do not repair. 
Replace only with identical electric cable.

■

Extension cable must be uncoiled during use. Coiled 
cables can overheat.

■

Make sure the power cord is positioned so that it will not 
be stepped on, tripped over or otherwise subjected to 
damage or stress.

■

Never carry the product by the power cord.

■

Never pull by the power cord to disconnect from the 
power supply.

■

Keep the power cord away from heat, oil and sharp 
edges.

■

Make sure voltage is correct for your machine. A 
nameplate on the product indicates the unit’s voltage. 
Never connect the product to an AC voltage that differs 
from this voltage.

■

Make sure the switch is in Off position before 
disconnecting from power supply.

■

For storage, always disconnect from power supply and 
wind cable.

■

Always wear protective non-slip footwear and long 
trousers.

■

Before use, check that there are no damaged parts. A 
defective switch or any part that is damaged should be 
properly repaired or replaced by an authorized service 
facility.

■

Consider the environment in which you are working. 
Keep the working area free from wires, sticks, stones 
and debris.

■

Make sure the trimmer head is properly installed and 
securely fastened.

■

Make sure all guards, deflectors and handles are 
properly and securely attached.

■

Avoid using machine in bad weather, especially if there 
is risk of lightning.

■

Use the trimmer in daylight or good artificial light.

■

Avoid using on wet grass.

■

Keep proper footing and balance at all times.

■

Do not walk backwards when trimming.

■

Walk, never run.

■

Keep the trimmer head below waist level.

■

Do not cut on surfaces other than grass on ground.

■

Never operate the trimmer with damaged guards or 
without guards in place.

■

Never fit a metal replacement line.

■

Keep hands and feet away from the cutting means at 
all times and especially when switching on the motor.

■

Never pick up or carry the trimmer by the electric cable.

■

Beware of objects thrown by the cutting line.

■

Switch off and disconnect from the power supply before:

–

servicing

–

leaving the trimmer unattended

–

cleaning your trimmer

–

changing accessories

–

checking for any damage after hitting an object