Microchip Technology SC70EV User Manual
SC70-6 and SOT-23-6/8 to DIP-8 Evaluation Board User’s Guide
DS51874A-page 12
© 2009 Microchip Technology Inc.
2.3
GETTING STARTED
The SC70-6 and SOT-23-6/8 to DIP-8 Evaluation Board is a blank PCB that allows the
user to configure the circuit to the exact requirements. The passive components use
the surface-mount 805 package layout.
This evaluation board supports the following Microchip product device families:
• A/D Converters (ADCs)
• Battery Management
• CAN
• Comparators
• D/A Converters (DACs)
• DC-to-DC Converters
• Digital Potentiometers (Digi-Pots)
• EEPROM Serial Memory
• Fan Controllers
• IrDA
• LIN
• Linear Regulators
• Operational Amplifiers (Op Amps)
• Piezoelectric Horn Driver
• Power MOSFET Drivers
• Programmable Gain Amplifiers (PGAs)
• Selectable Gain Amplifiers
• Smoke Detection Front End
• Switching Regulators
• Temperature Sensors
• Voltage References
• Voltage Supervisors and Detectors
• PICmicro
user to configure the circuit to the exact requirements. The passive components use
the surface-mount 805 package layout.
This evaluation board supports the following Microchip product device families:
• A/D Converters (ADCs)
• Battery Management
• CAN
• Comparators
• D/A Converters (DACs)
• DC-to-DC Converters
• Digital Potentiometers (Digi-Pots)
• EEPROM Serial Memory
• Fan Controllers
• IrDA
• LIN
• Linear Regulators
• Operational Amplifiers (Op Amps)
• Piezoelectric Horn Driver
• Power MOSFET Drivers
• Programmable Gain Amplifiers (PGAs)
• Selectable Gain Amplifiers
• Smoke Detection Front End
• Switching Regulators
• Temperature Sensors
• Voltage References
• Voltage Supervisors and Detectors
• PICmicro
®
Microcontrollers
Figure 2-1 shows the evaluation board circuit. The pins on the 8-pin SOT-23-8 and DIP
devices are tied together (pin number to pin number). The pins of the6-pin SC70 and
SOT-23 devices are tied as if the DIP was a 6-pin DIP. This circuit allows each pin to
individually have any of the following: a pull-up resistor, a pull-down resistor (or a
loading/filtering capacitor). Power supply filtering capacitors are connected between
the VDD and VSS pads (C1 and C2).
The circuit has a 6-pin header that can be used for PICkit Serial communication as well
as PIC ICSP. The signals of this header would need to be jumpered to the appropriate
device signal.
devices are tied together (pin number to pin number). The pins of the6-pin SC70 and
SOT-23 devices are tied as if the DIP was a 6-pin DIP. This circuit allows each pin to
individually have any of the following: a pull-up resistor, a pull-down resistor (or a
loading/filtering capacitor). Power supply filtering capacitors are connected between
the VDD and VSS pads (C1 and C2).
The circuit has a 6-pin header that can be used for PICkit Serial communication as well
as PIC ICSP. The signals of this header would need to be jumpered to the appropriate
device signal.