Microchip Technology TPG100001 User Manual
ICP
Family User’s Manual
Rev: 4.7.3 Jan-2011 Page 6 of 18
3 PASS/FAIL LEDs and Outputs
###
Conditions
PASS
LED
FAIL
LED
PASS
Output
FAIL
Output
1.
Power-up
2 sec ON
2 sec ON
2.
Operation in-progress
(busy)
(busy)
ON
ON
3.
Programming done:
PASS
ON
OFF
ON
OFF
4.
Programming done:
FAIL
(verification error)
OFF
ON
OFF
ON
5.
UUT problem during
operation:
- Vdd overload
- Vpp overload
- I2C communication error
operation:
- Vdd overload
- Vpp overload
- I2C communication error
OFF
Blink
OFF
ON
6.
Non-UUT problem during
standalone operation:
- database error
- device not supported
- no Keeloq® support
- no dsPIC® support
- etc.
standalone operation:
- database error
- device not supported
- no Keeloq® support
- no dsPIC® support
- etc.
OFF
Blink
OFF
OFF
7.
No firmware presents
(bootloader only)
(bootloader only)
Slow blink
OFF
OFF (not supported)
8.
Firmware upgrade
in-progress
in-progress
Fast blink
OFF
OFF (not supported)
4 Other LEDs (ICP2-Portable)
See
“ICP2-Portable Quick Start.pdf”
5 Standalone Operation without PC
Prepare an environment and transfer to programmer
– see paragraph 12 for details
NOTE: once the environment is saved in non-volatile
memory it’s automatically ready for programming
Short pin GO (:13) of the target connector to GND (:12) for at least 100ms to start programming
Observe PASS/FAIL LEDs or/and pins PASS (:14) and FAIL(:15)
– see paragraph 3 for details
6 Host Computer Requirements
Pentium-4 or greater IBM PC compatible
Resolution 1024x768 or higher
64MBytes of RAM
Windows-XP/Vista/7. Contact Softlog Systems for operation with Win-95/98/NT/2000
At least 50MBytes of hard disk space
CD-ROM drive
Free RS-232 or USB port
7 Installation
7.1
Preliminary Installation
7.1.1
Software Installation
To install the software supplied, follow the steps below: