Microchip Technology AC244006 User Manual
MPLAB
®
REAL ICE
™
IN-CIRCUIT
EMULATOR USER’S GUIDE
© 2006 Microchip Technology Inc.
DS51616A-page 41
Chapter 7. Hardware Specification
7.1
INTRODUCTION
The hardware and electrical specifications of the MPLAB REAL ICE in-circuit emulator
system are detailed.
system are detailed.
7.2
HIGHLIGHTS
This chapter discusses:
• Declaration of Conformity
• USB Port/Power
• Emulator Pod
• Standard Communication Board
• High-Speed Communication Boards
• Other Emulator Boards (Future)
• Target Board
• Declaration of Conformity
• USB Port/Power
• Emulator Pod
• Standard Communication Board
• High-Speed Communication Boards
• Other Emulator Boards (Future)
• Target Board
7.3
DECLARATION OF CONFORMITY
We
Microchip Technology, Inc.
2355 W. Chandler Blvd.
Chandler, Arizona 85224-6199
USA
hereby declare that the product:
MPLAB
Microchip Technology, Inc.
2355 W. Chandler Blvd.
Chandler, Arizona 85224-6199
USA
hereby declare that the product:
MPLAB
®
REAL ICE™ In-Circuit Emulator
complies with the following standards, provided that the restrictions stated in the
operating manual are observed:
Standards: EN61010-1
operating manual are observed:
Standards: EN61010-1
Laboratory Equipment
Microchip Technology, Inc.
Date: August 2006
Important Information Concerning the Use of the MPLAB REAL ICE In-Circuit Emulator
Due to the special nature of the MPLAB REAL ICE in-circuit emulator, the user is
advised that it can generate higher than normal levels of electromagnetic radiation
which can interfere with the operation of all kinds of radio and other equipment.
To comply with the European Approval Regulations therefore, the following restrictions
must be observed:
1. The development system must be used only in an industrial (or comparable)
Date: August 2006
Important Information Concerning the Use of the MPLAB REAL ICE In-Circuit Emulator
Due to the special nature of the MPLAB REAL ICE in-circuit emulator, the user is
advised that it can generate higher than normal levels of electromagnetic radiation
which can interfere with the operation of all kinds of radio and other equipment.
To comply with the European Approval Regulations therefore, the following restrictions
must be observed:
1. The development system must be used only in an industrial (or comparable)
area.
2. The system must not be operated within 20 meters of any equipment which may
be affected by such emissions (radio receivers, TVs etc.).