Microchip Technology DV164039 Data Sheet
PIC24FJ256DA210 Development Board User’s Guide
DS51911A-page 24
2010 Microchip Technology Inc.
FIGURE 3-6:
PIC24FJ256DA210 DEVELOPMENT BOARD
CONFIGURATION BITS
CONFIGURATION BITS
3.5.2
Connect and Enable MPLAB REAL ICE In-Circuit Emulator
1.
Connect the MPLAB REAL ICE in-circuit emulator module to the PC with the
USB cable.
USB cable.
2.
Connect the MPLAB REAL ICE in-circuit emulator to the PIC24FJ256DA210
Development Board with the short RJ-11 cable.
Development Board with the short RJ-11 cable.
3.
Apply power to the development board.
4.
From the Debugger menu, choose Select Tool > REAL ICE to set MPLAB REAL
ICE in-circuit emulator as the debug tool in MPLAB IDE.
ICE in-circuit emulator as the debug tool in MPLAB IDE.
Once selected, MPLAB IDE will connect to the MPLAB REAL ICE in-circuit emulator
and report that it has detected the module (Figure 3-7). Then it connects to the MPLAB
REAL ICE in-circuit emulator verifying the firmware loaded on the module is appropri-
ate for the selected device (PIC24FJ256DA210). If not, it will load the necessary firm-
ware. Once the firmware is verified to be correct it connects to the development board
and determines if the target device (i.e., the PIC24FJ256DA210) is present or not.
and report that it has detected the module (Figure 3-7). Then it connects to the MPLAB
REAL ICE in-circuit emulator verifying the firmware loaded on the module is appropri-
ate for the selected device (PIC24FJ256DA210). If not, it will load the necessary firm-
ware. Once the firmware is verified to be correct it connects to the development board
and determines if the target device (i.e., the PIC24FJ256DA210) is present or not.
Note:
Do not use the Configuration Bits window to set device configuration if con-
figuration macros are already used in the source code. To do this, check the
“Configuration Bits set in code” checkbox at the top of the Configuration bits
window. Refer to the “MPLAB IDE Simulator, Editor User’s Guide”
(DS51025) for additional information.
figuration macros are already used in the source code. To do this, check the
“Configuration Bits set in code” checkbox at the top of the Configuration bits
window. Refer to the “MPLAB IDE Simulator, Editor User’s Guide”
(DS51025) for additional information.
Note:
Upon first connection to the PIC24FJ256DA210 Development Board,
MPLAB IDE may need to download new firmware. Allow it to do so. If any
errors are shown, double click the error message to get more information.
MPLAB IDE may need to download new firmware. Allow it to do so. If any
errors are shown, double click the error message to get more information.