Microchip Technology AC244045 Data Sheet

 2006-2012 Microchip Technology Inc.

DS51292U-page 51

The header AC number is used for ordering the header. However, this number is not 
on the debug header, as the board is often used for multiple headers by inserting 
different ICE/ICD devices. To identify this debug header, use the following information.

This debug header can be used with the following targets:

1.

Customer target board for PIC18F1230/1330 devices. The target board should 
have an 18-pin DIP socket to connect to the 18-pin DIP socket on the debug 
header.

2.

PICDEM MC motor control demo board. Use the 28-pin DIP socket on both 
boards to mount the debug header on to the PICDEM MC board.

3.

PICDEM MC LV motor control demo board. Use the 28-pin DIP socket on both 
boards to mount the debug header on to the PICDEM MC LV board.

The following sections detail the configuration of the jumpers on the debug header for 
use with the above mentioned boards.

CUSTOMER TARGET BOARD

The default configuration is to remove all jumpers.

S1 is not populated and should not be used.

After the debug header is set up, do the following:

1.

Connect the header to the target board.

2.

Power the target board. You should see the red LED on the debug header turn 
on.

3.

Connect the debug tool to the debug header.

4.

Use MPLAB IDE/MPLAB X IDE and the debug tool to develop your application.

PICDEM MC/MC LV MOTOR CONTROL DEMO BOARDS

To run a BLDC motor on the PICDEM MC board or PICDEM MC LV board using the 
supplied firmware, use the following jumper setup:

S1 is not populated and should not be used.

AC162078

PIC18F1330-ICD

02-01896

J1

2-3

JP1

Open

J2

2-3

J3

2-3

JP2

Open

J5

2-3

J6

1-2

JP3

Open

J7

1-2