Microchip Technology MA330025-1 Data Sheet

 2009-2012 Microchip Technology Inc.

DS70616G-page 1

• 3.0V to 3.6V, -40ºC to +125ºC, DC to 60 MIPS

•

3.0V to 3.6V, -40ºC to +85ºC, DC to 70 MIPS

• Code-Efficient (C and Assembly) architecture
• Two 40-Bit Wide Accumulators
• Single-Cycle (MAC/MPY) with Dual Data Fetch
• Single-Cycle Mixed-Sign MUL Plus Hardware Divide
• 32-Bit Multiply Support

• 2% Internal Oscillator
• Programmable PLLs and Oscillator Clock Sources
• Fail-Safe Clock Monitor (FSCM)
• Independent Watchdog Timer
• Fast Wake-up and Start-up

• Low-Power Management modes (Sleep, Idle, Doze)
• Integrated Power-on Reset and Brown-out Reset
• 1.0 mA/MHz Dynamic Current (typical)
• 60  µA  I

PD

 Current (typical)

• Up to Seven PWM Pairs with Independent Timing
• Dead Time for Rising and Falling Edges 
• 8.32 ns PWM Resolution
• PWM Support for:

- DC/DC, AC/DC, Inverters, PFC, Lighting
- BLDC, PMSM, ACIM, SRM

• Programmable Fault Inputs
• Flexible Trigger Configurations for ADC Conversions

• Two Independent ADC modules:

- One ADC configurable as 10-bit, 1.1 Msps with four 

S&H or 12-bit, 500 ksps with one S&H

- One 10-bit ADC, 1.1 Msps with four S&H
- Eight S&H using both ADC 10-bit modules
- 24 analog channels (64-pin devices) up to 32 analog 

channels (100/121/144-pin devices)

• Flexible and Independent ADC Trigger Sources
• Comparators:

- Up to three Analog Comparator modules
- Programmable references with 32 voltage points 

• 27 General Purpose Timers:

- Nine 16-bit and up to four 32-bit Timers/Counters
- 16 OC modules configurable as Timers/Counters
- Two 32-bit Quadrature Encoder Interface (QEI) 

modules configurable as Timers/Counters

• 16 IC modules
• Peripheral Pin Select (PPS) to allow Function Remap
• Real-Time Clock and Calendar (RTCC) module

• USB 2.0 OTG-Compliant Full-Speed Interface
• Four UART modules (15 Mbps)

- Supports LIN/J2602 protocols and IrDA

®

• Four 4-Wire SPI modules (15 Mbps)
• Two ECAN™ modules (1 Mbaud) CAN 2.0B Support
• Two  I

2

C modules (up to 1 Mbaud) with SMBus Support

• Data Converter Interface (DCI) module with Support for 

I

2

S and Audio Codecs

• PPS to allow Function Remap
• Parallel Master Port (PMP)
• Programmable Cyclic Redundancy Check (CRC)

• 15-Channel DMA with User-Selectable 

Priority Arbitration

• UART, USB, SPI, ADC, ECAN™, IC, OC, Timers, 

DCI/I

2

S, PMP

• Sink/Source 10 mA on All Pins
• 5V Tolerant Pins
• Selectable Open-Drain, Pull-ups and Pull-Downs
• Up to 5 mA Overvoltage Clamp Current
• External Interrupts on All I/O pins

• AEC-Q100 REVG (Grade 1 -40ºC to +125ºC) Planned
• AEC-Q100 REVG (Grade 0 -40ºC to +150ºC) Planned
• Class B Safety Library, IEC 60730

• In-Circuit and In-Application Programming
• Five Program and Three Complex Data Breakpoints
• IEEE 1149.2 Compatible (JTAG) Boundary Scan
• Trace and Run-Time Watch