Microchip Technology AC164344 Data Sheet
© 2005 Microchip Technology Inc.
DS30177T-page 33
Hardware
MPLAB
®
ICD 2 Accessories
RS-232 and Power Supply Kit
Universal Power Supply and Serial Cable to support
using the ICD 2 for serial communications or with the
Universal Programmer Module. These items are
included with the MPLAB
using the ICD 2 for serial communications or with the
Universal Programmer Module. These items are
included with the MPLAB
®
ICD 2 Evaluation Kit
(DV164006) and MPLAB
®
ICD 2 Module ws
(DV164007) products.
Universal Programming Module
The Universal
Programming Module is
a handy, low-cost tool to
support programming of
DIP packaged products
from Microchip.
Programming Module is
a handy, low-cost tool to
support programming of
DIP packaged products
from Microchip.
It can be used in
conjunction with the
In-Circuit Debugger
conjunction with the
In-Circuit Debugger
(MPLAB ICD 2) to provide an easy means for
programming microcontrollers.
programming microcontrollers.
Seven flying leads break out the primary programming
lines needed for any microcontroller. These are
connected to the 40 breakout pins of the ZIF socket,
allowing any part to be configured to the necessary
programming lines.
lines needed for any microcontroller. These are
connected to the 40 breakout pins of the ZIF socket,
allowing any part to be configured to the necessary
programming lines.
Features
• ZIF Socket
• Supports up to 40-pin devices from 300 to 600 mil
width
• MPLAB ICD 2 Connector
MPLAB ICD 2 Header Interfaces
The header interface provides in-circuit debugging
capability to the 8-pin, 14-pin or 18-pin devices. The
header interface is connected in place of the target
device and houses a standard MPLAB ICD 2
connector. In-circuit debugging is done via an
MPLAB ICD 2. Once the code is debugged, the
debugged software can then be programmed into the
device and installed in the board, replacing the header.
capability to the 8-pin, 14-pin or 18-pin devices. The
header interface is connected in place of the target
device and houses a standard MPLAB ICD 2
connector. In-circuit debugging is done via an
MPLAB ICD 2. Once the code is debugged, the
debugged software can then be programmed into the
device and installed in the board, replacing the header.
Ordering Information:
AC162048
RS-232 and Power Supply Kit
AC162049
Universal Programming Module
AC162050
PIC12F629/675 MPLAB ICD 2 Header Interface Module
AC162051
MPLAB
®
ICD 2 Header Interface Module
AC162052
PIC16F630/676 MPLAB ICD 2 Header Interface Module (14-pin DIP)
AC162053
PIC16F648A/627A/628A MPLAB ICD 2 Header Interface Module (18-pin DIP)
AC162054
MPLAB
®
ICD 2 18-pin Header (PIC16F716)
AC162055
MPLAB
®
ICD 2 14-pin Header (PIC16F684)
AC162056
MPLAB
®
ICD 2 14-pin Header (PIC16F688)
AC162057
MPLAB
®
ICD 2 14-pin Header (PIC16F638/636)
AC162058
MPLAB
®
ICD 2 8-pin Header (PIC12F683)
AC162059
MPLAB
®
ICD 2 8/14-pin Header (PIC16F505)
Estimated availability CQ305
AC162060
MPLAB
®
ICD 2 20-pin Header (PIC16C785)
Estimated availability CQ305