Freescale Semiconductor Flexis Series Demo Board DEMOQE128 DEMOQE128 User Manual
Product codes
DEMOQE128
42
DEMOQE128 User Manual
8.5.2
J14 - Accelerometer g-Select2 Jumper G-SEL2
Selects g-Select2 to be logic low. This is the default setting.
Selects g-Select2 to be logic high. A user may control PTD0 in
firmware to set g-Select2
firmware to set g-Select2
Figure 8-12: Accelerometer g-Select2 Jumper settings (J14)
8.5.3
J15 - Accelerometer Sleep Mode Select Jumper SLEEP (J15)
Enables the 3-axis accelerometer. This is the default setting.
Puts the 3-axis accelerometer into sleep mode. The user may control
PTC4 in firmware to enable or disable the accelerometer. In this
configuration, the user needs to pay close attention to LED PTC4 and
RSTO configuration.
PTC4 in firmware to enable or disable the accelerometer. In this
configuration, the user needs to pay close attention to LED PTC4 and
RSTO configuration.
Figure 8-13: Accelerometer Sleep Mode Jumper settings (J15)