Tandberg Data StorageLibrary T40+, 24 slots, 1xLTO-3 8136-LTO User Manual
Product codes
8136-LTO
StorageLibrary Installation and User Guide
23
Figure 20. The Complete System.
Remove the Transport Locking Screws
To protect the library during transport, four transport locking screws hold the robotics in a locked
position. The screws are marked with red plastic tabs protruding between the magazines and the front
panel.
position. The screws are marked with red plastic tabs protruding between the magazines and the front
panel.
Caution
The transport locking screws must be removed before the StorageLibrary
can operate normally. Be careful not to drop any of the transport locking
screws inside the unit.
can operate normally. Be careful not to drop any of the transport locking
screws inside the unit.
Figure 21. Transport Locking Screws Marked with Red Plastic Tabs
The transport locking screws will be detected when the StorageLibrary is powered on. To remove the
screws follow the instructions below:
screws follow the instructions below:
Two T40+ units in a
Pass-Thru Mode.
Pass-Thru Mode.